Sanyo PLC-XU74 owner manual Remote Control Battery Installation, Operating Range

Page 12

Part Names and Functions

Remote Control Battery Installation

1

Open the battery

2

Install new batteries

3

Replace the

 

compartment lid.

 

into the compartment.

 

compartment lid.

Two AA size batteries

For correct polarity

(+ and –), be sure battery terminals are in contact with pins in the compartment.

To insure safe operation, please observe the following precautions:

Use two (2) AA or LR6 type alkaline batteries.

Always replace batteries in sets.

Do not use a new battery with a used battery.

Avoid contact with water or liquid.

Do not expose the remote control to moisture or heat.

Do not drop the remote control.

If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

Risk of explosion if a battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing any button. Maximum operating range for the remote control is about 16.4' (5 m) and 60° in front of the projector.

16.4' (5 m)

30°

30°

12

Image 12
Contents Model PLC-XU74 Features and Design Table of Contents To the Owner Risk of Electric Shock Do not OpenSafety Instructions Voor de klanten in NederlandInstalling the Projector in Proper Position Air CirculationMoving the Projector Compliance Federal Communication Commission NoticeTop Controls and Indicators i Speaker Air Intake Vent Part Names and FunctionsFront BackRear Terminal Top Control Remote Control Remote Control Battery Installation Operating RangeInstallation Adjustable FeetPositioning the Projector Connecting the AC Power Cord Projector sideConnecting to a Computer InstallationCables used for connection Connecting to Video Equipment Connecting to Component Video Equipment Selected Input Source and Lamp Mode Basic OperationTurning On the Projector PIN Code Input Dialog BoxTurning Off the Projector Basic OperationHow to Operate the On-Screen Menu Remote ControlTop Control On-Screen MenuMenu Bar Zoom and Focus Adjustment Keystone CorrectionSound Adjustment Remote Control OperationTimer button Auto PC buttonZoom buttons No Show buttonComputer Input Input Source SelectionDirect Operation Source Select MenuComputer System Selection Auto PC Adjustment To store adjustment parametersMenu Operation Auto PC Adj Manual PC Adjustment Reset Mode freeTo clear adjusted data To store adjusted dataImage Level Selection Image Level Adjustment Screen Size Adjustment NormalTrue WideFor zooming in and out the images Digital zoom +Digital zoom Video Input Input Source Selection Video, S-VideoSource Select Menu Video Input Source Selection Component, RGB Scart 21-pin InputVideo System Selection AutoAV System Menu Video or S-Video AV System Menu ComponentCinema Image 1~4Video Input Color TintNoise reduction ProgressiveProvide the image at a normal video aspect ratio Setting SettingLogo Logo and Logo PIN code lock settings DisplayLogo select Capture Setting CaptureLogo PIN code lock To Enter the Logo PIN code Ceiling RearInput search Terminal On start Security Key lock and PIN code lock settings Key lockPIN code lock Change the PIN code lock setting Change the PIN codeFactory default FanLamp counter Maintenance and Cleaning Maintenance & CleaningThen check the matters below Cleaning the Air Filters Attaching the Lens CoverCleaning the Projection Lens Cleaning the Projector CabinetLamp Replacement Reset the lamp replacement counterLamp Handling Precautions Lamp Replacement CounterTroubleshooting AppendixAppendix AppendixMenu Tree Computer Input/Video InputAppendix Video Input Indicators and Projector Condition IndicatorsCompatible Computer Specifications ResolutionTechnical Specifications Mechanical InformationOptional Parts Configurations of Terminals Service Port Connector Terminal Mini DIN 8-PINUSB Connector Series B Logo PIN Code Lock No PIN Code Number MemoPart No LG6P1P0156-- KT6AC