Sanyo PLC-XU74 owner manual Lamp Replacement, Reset the lamp replacement counter

Maintenance and Cleaning

Lamp Replacement

When the life of the projection lamp of this projector draws to an end, the LAMP REPLACE indicator emits a yellow light. If this indicator lights yellow, replace the lamp with a new one promptly.

This indicator is yellow when the life of the projection lamp

WARNING:draws to an end.

TURN OFF THE UV LAMP BEFORE  OPENING THE LAMP COVER

Top Control

POWER	W	LAMP REPLACE
ON	NPUT	KEYSTONE
SELECT
		+
-		VOLUME
VOLUME

CAUTION CAUTION

Allow a projector to cool, for at least 45 minutes before you open the Lamp cover. The inside of the projector can become very hot.

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

Follow these steps to replace the lamp.

1	Turn off the projector and disconnect the AC power
	cord. Allow the projector to cool for at least 45
	minutes.
2	Remove the screw with a screwdriver, and remove
3	the lamp cover.
	Remove 2 screws of the lamp with a screwdriver
4	and pull out the lamp by grasping the handle.
	Replace the lamp with a new one and tighten the 2
	screws back into position. Make sure that the lamp
	is set properly. Replace the lamp cover and tighten
	the screw.
5	Connect the AC power cord to the projector and
6	turn on the projector.
	Reset the lamp replacement counter.
	See "Lamp Replacement Counter" on the next
	page .

Lamp Cover Screw

Screw

Lamp

Screw

Handle

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

● Model No. of your projector	: PLC-XU74
● Replacement Lamp Type No.	: POA-LMP106
	(Service Parts No. 610 332 3855)

54