Sanyo PLC-XU74 Computer Input, Input Source Selection, Direct Operation, Source Select Menu

Computer Input

Input Source Selection

Direct Operation Top Control

Choose either Computer 1 or Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control. Before using these buttons, correct input source should be selected through Menu operation as described below.

INPUT button INPUT button Computer 1

Computer 2 ✳

Video

Remote Control

COMPUTER button

COMPUTER button

Computer 1

Computer 2 ✳

✳See Note at the bottom of this page.

Menu Operation

1	Press the MENU button to display the On-Screen
	Menu. Press the Point 7 8 buttons to move the
	red framed pointer to the Input Menu icon.
2	Press the Point ed buttons to move the red
	arrow pointer to either Computer 1 or Computer
	2, and then press the SELECT button.
3	After the Source Select Menu appeared for
	Computer 1, move the pointer to RGB and then
	press the SELECT button.

Input Menu

Computer

1

Input Menu

Input Menu icon

Move the pointer (red arrow) to Computer 1 and press the SELECT button.

Source Select Menu

Move the pointer to RGB and press the SELECT button.

Computer Input

✔ Note:	Input Search function is set On1
• When the
or On2, the	input signal will be searched
automatically (p.45)

• C o m p u t e r 2 i s n o t d i s p l a y e d w h e n t h e COMPUTER IN 2/MONITOR OUT terminal is set as Monitor out. (p.46)

•Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only RGB signal.

Move the pointer (red arrow) to Computer 2 and press the SELECT button.

25