Sanyo PLV-Z60 owner manual Turning Off the Projector

Basic Operation

Turning Off the Projector

1	Press the POWER ON/STAND-BY button on the top control
	or on the remote control. “Power off?” appears on the
	screen. Press the POWER ON/STAND-BY button again to
	turn off the projector.
	When the Power off confirmation function is set to “Off,”
	the projector can be turned off without the confirmation
	message. (See “Power off confirmation” on page 38.)
		“Power off?” disappears after 4 seconds.
	The automatic slide shutter closes and the POWER indicator
	starts to blink red. The blinking continues for about 60
	seconds while the cooling fans are running.
2	When the projector is cooled down enough to be turned on
	again, the POWER indicator becomes red. Then you can turn

the Main On/Off switch off and unplug the AC power cord.

TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR

ON, WAIT AT LEAST FIVE (5) MINUTES BEFORE TURNING IT

OFF.

DO NOT UNPLUG AC POWER CORD WHILE COOLING FANS

ARE RUNNING OR BEFORE POWER INDICATOR STOPS

BLINKING. OTHERWISE IT WILL RESULT IN SHORTENING

LAMP LIFE.

✔Notes:

•If the automatic slide shutter is closed during operation, the projector is automatically turned off for safety. Be sure to turn off the projector by pressing the POWER ON/STAND-BY button on the top control or on the remote control after use.

•While the POWER indicator is blinking, the lamp is being cooled down and the projector cannot be turned on. Wait until the POWER indicator becomes red to be turned on again.

•Do not operate the projector continuously without rest. Continuous use may result in shortening the lamp life. Turn off the projector and let stand for about an hour in every 24 hours.

•The running speed of cooling fans is changed according to the temperature inside the projector.

•If the WARNING indicator blinks or emits red light, see “Warning Indicator” on page 42.

•Do not put the projector in a case before it is cooled enough.

19