Sanyo PLV-Z60 owner manual Mounting, Rear, Off Normal Hdmi setup Background

Setting

Mounting

This function is used to select the installation methods of the projector. Press the Point 8 or OK buttons to switch between each option.

Off . . . . . Cancel the selected installation method.

Ceiling . . Project the image from the ceiling-mounted projector. The picture is top/bottom and left/right reversed.

Wall . . . . Project the image from a wall-hanging projector. The picture is left/right reversed.

Rear

When this function is set to “On,” the picture is left/right reversed. This function is used to project the image to a rear projection screen. Press the Point 8 or OK buttons to switch On/Off.

HDMI setup

Select L1 or L2 according to the output signal of video equipment. Press the Point 8 or OK buttons to switch between each option.

1:L1 2:L1 . . . . . Set HDMI1 terminal to L1, HDMI2 to L1 1:L2 2:L1 . . . . . Set HDMI1 terminal to L2, HDMI2 to L1 1:L1 2:L2 . . . . . Set HDMI1 terminal to L1, HDMI2 to L2 1:L2 2:L2 . . . . . Set HDMI1 terminal to L2, HDMI2 to L2

L1 . . . . . When the output of video equipment is set to “STANDARD.”

L2 . . . . . When the output of video equipment is set to “ENHANCED.”

The names for the output setting of video equipment vary from equipment to equipment. For details, refer to the owner’s manual of video equipment.

Background

Select the background screen for when no input signal is detected. Press the Point 8 or OK buttons to switch between each option.

Blue . . . . Project a blue background

Logo . . . Project an image selected in the Logo setting. Black . . . Project a black background

✔Note:

•When the Logo setting (see page 38) is set to “Off” with the “Logo” background, the Background setting will be switched to “Blue.”

Off (Normal)

HDMI setup

Background

Ceiling

Wall

Rear (On)

Press the Point 8 or OK buttons to select L1 or L2 according to the output signal of video equipment.

37