Sanyo PLC-XE50 owner manual Computer Input, Input Source Selection, Input Menu, Source Select Menu

Computer Input

Input Source Selection

Direct Operation

Press the COMPUTER button on the remote control to select either Computer 1 or Computer 2.

Before using the COMPUTER button, select the correct input source through Menu operation as described below.

Menu Operation

1	Press the MENU button to display the On-Screen
	Menu. Use the Point 7 8 buttons to move the red
	frame pointer to the Input Menu icon.
2	Use the Point ed buttons to move the red arrow
	pointer to either Computer 1 or Computer 2, and then
	press the SELECT button.
3	After the Source Select Menu appeared for Computer
	1, move the pointer to RGB and then press the

SELECT button.

✔Note:

•Computer 2 is not displayed when the COMPUTER IN 2/ MONITOR OUT terminal is set as Monitor out (p.48). •Computer 2 (COMPUTER IN 2/MONITOR OUT) can accept only the RGB signal.

•When the Input Search function is set On1 or On2, the input signal will be searched automatically (p.48)

Remote Control

COMPUTER button

/

COMPUTER button

Computer 1

Computer 2*

*See Notes at the bottom of this page.

Input Menu icon

Input Menu

Move the pointer (red arrow) to Computer 1 and press the SELECT button.

Computer

1

Source Select Menu

Move the pointer to RGB and press the SELECT button.

Input Menu

Move the pointer (red arrow) to Computer 2 and press the SELECT button.

26