Setting
Remote control
This projector provides two different remote control codes; the
When the projector is operated in “Code 2,” both the projector and the remote control must be switched to “Code 2.”
To change the code for the projector:
Select either “Code 1” or “Code 2” in this Setting Menu.
To change the code for the remote control: Press and hold both the MENU and IMAGE buttons together for more than 5 seconds. After changing the code, make sure the remote control operates properly.
✔Note:
•When different codes are set on the projector and on the remote control, any operation cannot be made. In that case, switch the code on the remote control to fit the code on the projector.
•if the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
Security (Alarm and PIN code lock setting)
This function allows you to use PIN code lock and Alarm function to set the security for the projector operation.
PIN code lock
This function prevents the projector from being operated by unauthorized persons and provides the following setting options for security.
Off…… The projector is not locked with the PIN code.
On1……Requires to enter a PIN code every time
turning on the projector.
On2……Requires to enter a PIN code to operate the
projector once the power cord is unplugged; as long as the AC power cord is connected, the projector can be operated without a PIN code.
Whenever you change the PIN code lock setting or the PIN code (a
Remote control
Press and hold MENU and IMAGE buttons for more than 5 seconds.
PIN code lock
When the projector is locked with the PIN code, the PIN code lock symbol appears on the menu bar.
50