Sanyo PLC-XE50 owner manual Remote Control does not work, Appears on the screen

Appendix

The Remote Control does not work.

–  Check the batteries.

–  Make sure no obstruction is between the projector and the remote control.

–  Make sure you are not too far from the projector when using the remote control. Maximum operating range is 11.5’ (3.5 m).

–  Make sure the code of the remote control is conformed to that of the projector (see page 50).

Indicators blinks or lights.	–  Check the status of the projector with referring to “INDICATORS AND
	PROJECTOR CONDITION” on page 67.
	–  For Alarm indicator, see pages 53-54.
Alarm does not stop ringing.	–  Connect the AC power cord to the AC outlet. (Alarm will not stop ringing
	when the alarm goes off while trying to remove the rechargeable battery
	cover.) See page 53-55.
Warning mode is not turned on.	–  If you cannot hear the bleeping sound when you press the Alarm buttons,
	you are not pressing the buttons correctly. Try to set the Alarm setting
	again. See page 53.
Computer 2 cannot be selected.	–  Select Computer 2 in the Terminal function (see page 48).
The Terminal function cannot be	–  The Terminal function cannot be selected after Computer 2 is selected.
	Select other input source such as Computer 1 or Video with the
selected.	COMPUTER button or the VIDEO button on the remote control so that the
	Terminal function can be selected.
	– Your operation is invalid. Operate correctly.
appears on the screen

Unable to unlock the Logo PIN code lock or Security PIN code lock.

–  Contact the dealer where you purchased the projector or the service center.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

The CE Mark is a Directive conformity mark of the European Community (EC).

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc. It is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty and electrical hazards.

Pixelworks ICs used.

64