Antitheft Alarm Function
Charge the built-in batteries
Set the Battery charge option in the Alarm setting menu to “Auto.” The default setting is “Auto.”
As long as the AC power cord is connected and this option is set to “Auto,” the
The “Charging” appears dimmed when the battery is fully charged or the Battery charge option is set to “Off,” or if charging malfunction occurs. Set the option to “Off” when not using the Alarm function. This can save the power and battery life.
Replace the rechargeable batteries
Use only the specified battery for this projector. Using other types of battery may cause accident or fire hazard.
Replacement Battery: SANYO
How to replace the rechargeable batteries
1 | Unplug the AC power cord from a wall outlet. |
2 | Set the Alarm function to “Off” (see page 53). If it is |
not released, the alarm will start ringing when you try | |
| to remove the rechargeable battery cover. |
3 | Remove the screw from the rechargeable battery cover |
| and open the cover. |
4 | Pull out the battery connector and remove the battery. |
5 | Install new battery and plug the connector into the |
| socket. |
| Note: The battery connector has polarity. Observe |
| battery polarity when installing. |
6 | Put back the battery cover and secure it with the |
| screw. |
Caution: Tighten the screw securely. If you fail to do so, the alarm will not operate. Do not use any other screws. This may cause damage to the projector.
✔Note:
• The PIN code and settings you have changed are effective even after the battery is changed.
•When replacing the rechargeable batteries, protect the infrared remote receiver with a soft cloth to avoid damaging it.
•Unplug the battery connector if you carry your projector frequently and use the carrying case. If you do not unplug the battery connector, the alarm may be triggered when the Alarm buttons are accidentally pressed inside the carrying case..
Screw
Remove the screw and open the battery cover.
Install the battery, then put back the battery cover and secure it with the screw.
55