Appendix
| | – Adjust focus of the projector (see page 24). |
| | – Provide proper distance between the projector and the projection screen |
| | (see page 14). |
| Image is out of focus. | – Check the projection window to see if it needs cleaning (see page 61). |
| – Moving the projector from a cool to warm place may result in moisture |
| | condensation on the projection lens. If this occurs, leave the projector off |
| | and wait until condensation evaporates. |
| | – Projecting from excessive slant angle to the screen may cause keystone |
| | distortion and partial imperfect focus. |
| | |
| | – Check if “Contrast” or “Brightness” are adjusted properly. (See page 34, |
| | 42) |
| Picture is not bright enough. | – Check if “Image level” is selected properly. (See pages 32-33, 40-41) |
| – Check the Lamp control function. ( See “SETTING” section on page 50) |
| |
| | – Check the Lamp replace indicator. If it lights, the end of lamp life is |
| | approaching. Replace the lamp with a new one promptly. (See page 62) |
| The color is strange. | – Check the Input signal, color system, video system, or computer system |
| mode. |
| | – Adjust the Image Level properly. See pages 32-33, 40-41. |
| | |
| Image is Left/Right reversed. | – Check the Ceiling/Rear function (see page 49). |
| Image is Top/Bottom reversed | – Check the Ceiling function (see page 49). |
| | |
| The image is distorted or runs off. | – Check “PC Adjustment” menu or “ Screen” menu and adjust them. |
| | |
| | – Check the audio cable connection from audio input source. |
| | – Adjust the audio source. |
| | – Press the Volume + button (see page 25). |
| No sound | – Press the Mute button (see page 25). |
| – Is the image projected? You will hear the sound only when the |
| |
| | image is projected. |
| | – When the AUDIO OUT is plugged in, the projector’s built-in speaker is not |
| | available. |
| | |
Auto PC adjustment function does not work.
– Check the Input signal. Auto PC Adjustment function can not work when 480p, 575p, 720p, 480i, 575i, 1035i, or 1080i is selected. (See page 29)
| Some displays are not seen during | – Check the Display function (see page 46). |
| the operation. |
| |
The setting does not remain after turning off power.
– Make sure you selected “Store” after adjusting settings. Some settings can not be stored if not registered with “Store”.
| Power management function does | – Power management function can not work while “Freeze” or “No Show” |
| not work. | function is running. |
| | |
| Image disappears automatically. | – Check the power management function in the Setting. The power |
| management is set to "On" at the factory. |
| |
| | |
| Capture function does not work. | – Check the connection and input signal to see if there is signal. |
| | |