Auto setup, Input search, Auto Keystone

Setting

Auto setup

This function enables Input search, Auto Keystone correction and Auto PC adjustment by pressing the AUTO SETUP button on the top control or the AUTO SET button on the remote control. Settings for those functions can be altered as follows:

Input search

This function detects the input signal automatically. When a signal is found, the search will stop. Use the Point ▲▼ buttons to select one of the following options.

Off	Input search will not work.
On1	Input search works under the following situation.
	– When pressing the AUTO SETUP button on
	the top control.
	– When pressing the AUTO SET button on the
	remote control.

On2.......... Input search works under the following situation.

–When turning on the projector by pressing the ON/STAND-BY button on the top control or the remote control.

–When pressing the AUTO SET button on the remote control.

–When pressing the AUTO SETUP button on the top control.

–When the current input signal is cut off.* * If the No show or Freeze function is active, cancel it to

activate the Input search. It is also unavailable when On-Screen menu is displayed.

Auto PC adj..

On . . . . Enables Auto PC Adjustment when pressing the AUTO SET button on the remote control or the AUTO SETUP button on the top control.

Off . . . . Disables Auto PC Adjustment.

Auto Keystone

Auto . . . Always works and corrects keystone distortion according to the projector's tilt.

Manual . . Works only when pressing the AUTO SETUP button on the top control or the AUTO SET button on the remote control.

Off . . . . Disables Auto Keystone.

Note:

•While Input search is set to On1 or On2, the status of Input and Lamp are displayed every time the signal is switched.

•Only the last selected input source can be detected.

•During Input search is in progress, If the MENU button or the ON/STAND-BY button is pressed, Input search will stop. If the COMPUTER 1/2 button or VIDEO or COMPONENT or S-VIDEO button is pressed, Input search will stop and go back to the button's input signal.

•Input search, Auto PC adj.. and Auto Keystone cannot be set Off at the same time.

Auto setup

Note:

•Auto Keystone corrects vertical distortion only, not correct horizontal distortion.

•The Auto Keystone function cannot work when the Ceiling feature is set On in the Setting menu (p.49).

•Perfect correction of the image distortion cannot be ensured with the Auto setup function. If the distortion is not corrected properly by pressing the AUTO SETUP or the AUTO SET button, adjust manually by pressing the KEYSTONE button on the remote control or selecting Keystone in the Setting menu (pp.23, 45).

•Fine sync, Total dots, Horizontal and Vertical position of some computers cannot be fully adjusted with the Auto PC Adjustment function. When the image is not provided properly with this operation, manual adjustments are required (pp.30-31).