Part Names and Functions
Remote Control Battery Installation
1 | Open the battery |
compartment lid. |
2 | Install new batteries | 3 | Replace the |
into the compartment. | compartment lid. |
Two AAA size batteries
For correct polarity
(+ and
To ensure safe operation, please observe the following precautions : ● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
●Do not use a new battery with a used battery.
●Avoid contact with water or liquid.
●Do not expose the remote control to moisture or heat.
●Do not drop the remote control.
●If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
●Risk of an explosion if battery is replaced by an incorrect type.
●Dispose of used batteries according to the instructions or your local disposal rule or guidelines.
Remote Control Operating Range
Point the remote control toward the projector (Infrared Remote Receiver) when pressing the buttons. Maximum operating range for the remote control is about 16.4'(5 m) and 60 degrees in front of the projector.
16.4’ (5 m)
Remote Control Code
The two different remote control codes (Code 1 - Code 2) are assigned to this projector. Switching the remote control codes prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time. Change the remote control code for the projector first before changing that for the remote control. See "Remote control" in the Setting Menu on page 54.
Press and hold the MENU and IMAGE buttons for more |
| While pressing the MENU |
than five seconds to switch between the Code 1 and Code | HDMI | button, press the IMAGE |
2. The initial code is set to Code 1. |
| button more than five |
|
| seconds to switch between |
|
| the codes. |
|
| MENU button |
|
| IMAGE button |
12