Setting
Standby mode |
|
This function is available when operating the projector via |
|
network. |
|
Network..... Supply the power to the network function even |
|
after turning off the projector. You can turn on/ |
|
off the projector via network, modify network |
|
environment, and receive an |
|
projector status while the projector is powered |
|
off. |
|
Eco............. Select Eco when you do not use the projector |
|
via network. The projector’s network function | Power management |
will stop when turning off the projector. |
|
Refer to the owner’s manual of “Network |
|
Operation”. |
|
Note: | Timer left before Lamp is off. |
• Factory default is Network. |
|
• When Eco is selected and the projector is in |
|
the communication of |
|
available. |
|
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready | When the lamp has been fully cooled |
| down, the POWER indicator changes |
| to green blinking. In this condition, the |
| projection lamp will be turned on if the |
| input signal is reconnected or any button |
Shut down | on the remote control is pressed. |
When the lamp has been fully cooled | |
Off | down, the power will be turned off. |
Power management function is off. | |
Timer | If the input signal is interrupted and |
| no button is pressed for more than |
| 30 seconds, the timer display with No |
| signal appears. It starts the countdown |
| until the lamp is turned off. Use the Point |
| ▲▼ buttons to set the Timer(1~30Min). |
Note:
Factory default is Ready: 5 Min.
51