Hitachi CP-X2510N, CP-X3010N user manual Connection, Command Control via the Network

Page 11

1.

2.

Command Control via the Network

Command Control via the Network

When the projector connects network, the projector can be controlled with RS- 232C commands from the computer with web browser.

For details of RS-232C commands, refer to RS-232C Communication / Network command table (&17).

Connection

Turn off the projector and the computer.

Connect the projector's LAN port and the computer's LAN port with a LAN cable. Use the cable that fulfi lls the specifi cation shown in fi gure (Use CAT-5

or greater LAN Cable when LAN ports are used )

3. Turn the computer on, and after the computer has started up turn the projector on.

LAN cable (CAT-5 or greater)

LAN					LAN

11

Downloaded from www.Manualslib.com manuals search engine

Image 11

Contents CP-X2010N/CP-X2510N/CP-X3010N Example of computer signalInitial set signals Computer IN1, B Computer IN2, C Monitor OUT Connection to the portsVideo Audio IN1, J Audio IN2 USB To input component video signal to Computer in ports RS-232C Communication ConnectionProtocol Communicaion settingsResponse code / Error code h shows hexadecimal Command Control via the Network Port1 Port Communicaion PortTCP #9715 Command format Command control settingsAutomatic Connection Break AuthenticationNetwork Bridge Communication Communication settings On next RS-232C Communication / Network command tableDefault Be EF Custom C7 FF Be EF 7C FF 7C D1 Be EF Auto Adjust OFF Be EF Computer IN1 AB C3 Component Not all of the languages in the table are supported On next Original Be EF Active Iris is available only for CP-X2510N and CP-X3010N High Be EF Avmt PJLink commandInst ?

Related manuals

Manual 1 pages 10.35 Kb

Manual 1 pages 27.63 Kb