Hitachi CP-X2510N, CP-X3010N user manual Connection, Network Bridge Communication

Page 15

Network Bridge Communication

Network Bridge Communication

This projector is equipped with NETWORK BRIDGE function.

When the projector connects to the computer by LAN communicaton, an external device that is connected with this projector by RS-232C communication can be controlled from the computer as a network terminal.

For details, see the 3.7 Controlling the external device via the projector(using the NETWORK BRIDGE function) - Network Guide.

Connection

1. Connectcable. the computer's LAN port and the projector's LAN port with a LAN 2. Connect the projector's CONTROL port and the RS-232C port of the

devices that you want to control with a RS-232C cable.

3. Turnon. the computer on, and after the computer has started up turn the projector

4. Set the COMMUNICATION TYPE to NETWORK BRIDGE. (&OPTION menu - SERVICE - COMMUNICATION in the User's Manual - Operating Guide)

LAN

LAN

CONTROLRS-232C

15

Downloaded from www.Manualslib.com manuals search engine

Image 15
Contents CP-X2010N/CP-X2510N/CP-X3010N Example of computer signalInitial set signals Computer IN1, B Computer IN2, C Monitor OUT Connection to the portsVideo Audio IN1, J Audio IN2 USB To input component video signal to Computer in ports RS-232C Communication ConnectionProtocol Communicaion settingsResponse code / Error code h shows hexadecimal Command Control via the Network Port1 Port Communicaion PortTCP #9715 Command format Command control settingsAutomatic Connection Break AuthenticationNetwork Bridge Communication Communication settings On next RS-232C Communication / Network command tableDefault Be EF Custom C7 FF Be EF 7C FF 7C D1 Be EF Auto Adjust OFF Be EF Computer IN1 AB C3 Component Not all of the languages in the table are supported On next Original Be EF Active Iris is available only for CP-X2510N and CP-X3010N High Be EF Avmt PJLink commandInst ?
Related manuals
Manual 1 pages 10.35 Kb Manual 1 pages 27.63 Kb