Hitachi CMP5000WXU, CMP5000WXJ user manual Power Cord Connection

Page 20

English

Installation and Connections

Power Cord Connection

Connect the power cord after all component connections have been completed.

1Connect the power cord to this unit.

2Plug the power cord into a power outlet.

Installation and Connections

CAUTION

÷Use only the power cord provided.

÷Do not use a power supply voltage other than that indicated (AC 100 - 120 V, 50/60 Hz) as this may cause fire or electric shock.

÷For the plasma display, a three-core power cord with a ground terminal is used for efficiency protection. Always be sure to connect the power cord to a three-pronged grounded outlet and make sure that the cord is properly grounded. If you use a power source converter plug, use an outlet with a ground terminal and screw down the ground line.

Image 20

Contents CMP5000WXU Manuel Utilisateur CMP5000WXJ English Safety Guidelines Safety GuidelinesSafety Guidelines III FCC Federal Communications Commission Statement Warning USER’S Manual ¶ Supports wide range of computer signal formats ¶ Power-Saving Design¶ Introduces newly developed 50 XGA Wide Plasma Panel ¶ High reliability for commercial applicationsContents About operations in this manual How to Use This ManualBefore Proceeding Checking Supplied Accessories Part Names and Functions Main UnitMain unit Operation panel on the main unitWhen handling the remote control unit Remote Control UnitInserting the batteries Remote control unit Operating range of the remote control unit Connection PanelAudio Output Stereo mini jack ~ Speaker L terminalAudio Input Stereo mini jack Installation and Connections Installation of the UnitWall-mount installation of the unit Rear view diagramWhen connecting to INPUT2 Installation and ConnectionsConnection to INPUT1 and INPUT2 Connection to a personal computerConnection of G on Sync analog RGB source When connecting to INPUT1When connecting to Output INPUT1 Connecting the speakers Audio ConnectionsConnection of composite Sync analog RGB Source Making connections to the audio inputs on this unitPower Cord Connection How to Route Cables Organize cables together using the provided speed clampsAndInstallation To attach the speed clamps to the main unitScreen Mode setup Setting Up the SystemSetup after Connection Clamp Position setup Setup of Clamp PositionSetting Up the System Press 5/∞ to select Clamp Position Press SET to select LockedPress STANDBY/ON to put this unit in the operation mode OperationsSelecting an Input Source Before you begin, make sure you haveTo adjust the volume Press Volume on the remote control unitPress Display on the remote control unit Press Muting on the remote control unitDuring personal computer signal input Screen Size SelectionChanging the screen size Press Screen Size to select the sizePartial Image Enlargement Automatic Power OFF Press 5/∞ to select either the PowerManagement or Auto Power OFF mode When using InputTo reset Picture mode settings to the default Display Panel AdjustmentsAdjusting the Picture Quality Adjusting the Image Position and Clock Automatic Adjustment To reset Screen mode settings to the default Press 2/3 to carry out the adjustmentScreen mode adjustment items Press 2/3 to select ScreenOther Operations Rewriting the Input DisplayOther Operations Press SET to select Input LabelPower Control Function Press SET to select Power ControlPress 2/3 to select Option Press MenuPress 5/∞ to select Audio OUT Audio Output Audio OUTOther Operations Press SET to select Input Cleaning TroubleshootingAbout the self diagnosis mode Additional InformationGeneral problems Problems commonly mistaken as breakdownAdditional cautions STANDBY/ON indicatorPanel sticking and after-image lag Specifications AccessoriesGeneral Input/outputPC signal compatibilty table INPUT1, INPUT2 SupplementInformation AdditionalSupplement Explanation of Terms Pin No Input Output