Hitachi CMP5000WXJ, CMP5000WXU user manual USER’S Manual

Page 7

English

USER’S MANUAL

Thank you very much for purchasing the HITACHI Plasma Display Monitor.

Before using your monitor, please carefully read the “SAFETY GUIDELINES” and this “USER’S MANUAL” so you will know how to operate the monitor properly. Keep this manual in a safe place. You will find it useful in the future.

Notes on Installation Work:

This product is marketed assuming that it is installed by qualified personnel with enough skill and competence. Always have an installation specialist or your dealer install and set up the product. HITACHI cannot assume liabilities for damage caused by mistake in installation or mounting, misuse, modification or a natural disaster.

Note for Dealers:

After installation, be sure to deliver this manual to the customer and explain to the customer how to handle the product.

Image 7

Contents CMP5000WXU Manuel Utilisateur CMP5000WXJ English Safety Guidelines Safety GuidelinesSafety Guidelines III FCC Federal Communications Commission Statement Warning USER’S Manual ¶ High reliability for commercial applications ¶ Supports wide range of computer signal formats¶ Power-Saving Design ¶ Introduces newly developed 50 XGA Wide Plasma PanelContents Before Proceeding How to Use This ManualAbout operations in this manual Checking Supplied Accessories Operation panel on the main unit Part Names and FunctionsMain Unit Main unitInserting the batteries Remote control unit Remote Control UnitWhen handling the remote control unit Connection Panel Operating range of the remote control unitAudio Input Stereo mini jack ~ Speaker L terminalAudio Output Stereo mini jack Rear view diagram Installation and ConnectionsInstallation of the Unit Wall-mount installation of the unitConnection to a personal computer When connecting to INPUT2Installation and Connections Connection to INPUT1 and INPUT2When connecting to Output INPUT1 When connecting to INPUT1Connection of G on Sync analog RGB source Making connections to the audio inputs on this unit Connecting the speakersAudio Connections Connection of composite Sync analog RGB SourcePower Cord Connection To attach the speed clamps to the main unit How to Route CablesOrganize cables together using the provided speed clamps AndInstallationSetup after Connection Setting Up the SystemScreen Mode setup Press SET to select Locked Clamp Position setupSetup of Clamp Position Setting Up the System Press 5/∞ to select Clamp PositionBefore you begin, make sure you have Press STANDBY/ON to put this unit in the operation modeOperations Selecting an Input SourcePress Muting on the remote control unit To adjust the volumePress Volume on the remote control unit Press Display on the remote control unitPress Screen Size to select the size During personal computer signal inputScreen Size Selection Changing the screen sizePartial Image Enlargement When using Input Automatic Power OFFPress 5/∞ to select either the Power Management or Auto Power OFF modeAdjusting the Picture Quality Display Panel AdjustmentsTo reset Picture mode settings to the default Adjusting the Image Position and Clock Automatic Adjustment Press 2/3 to select Screen To reset Screen mode settings to the defaultPress 2/3 to carry out the adjustment Screen mode adjustment itemsPress SET to select Input Label Other OperationsRewriting the Input Display Other OperationsPress Menu Power Control FunctionPress SET to select Power Control Press 2/3 to select OptionOther Operations Press SET to select Input Audio Output Audio OUTPress 5/∞ to select Audio OUT Additional Information CleaningTroubleshooting About the self diagnosis modeProblems commonly mistaken as breakdown General problemsPanel sticking and after-image lag STANDBY/ON indicatorAdditional cautions Input/output SpecificationsAccessories GeneralAdditional PC signal compatibilty table INPUT1, INPUT2Supplement InformationPin No Input Output Supplement Explanation of Terms