NEC SX4000 Operating Multiple Projectors with Remote Control, Projector ID= Remote Address =

Operating Multiple Projectors with Remote Control

You can operate multiple projectors with the same remote control in wireless operation.

To do so:

1. Select [Menu] → [Projector Options] → [Setup] → [Page 5] → [Projector ID] and assign an ID number to each projector. See also page E-39.

2.On the remote control specify the ID number of the projector to be adjusted. Press and hold the CTL and press MENU (ADDRESS) button to enter the ID number.

You can operate the projector assigned the same ID number as the remote control.

Projector ID= 01 Projector ID= 02 Projector ID= 03

Remote Address = 03

You can daisy-chain multiple projectors and operate them separately with the same remote control in wired operation. To do so:

1.Use the remote control cable to connect the REMOTE 2 Output of one projector to the REMOTE 2 Input of the next projector until all the projectors are connected. Only one remote control cable is supplied with each projector.

2.Specify a unique projector ID for each projector.

3.Specify the same remote address as the projector ID to be adjusted.

NOTE: Specifying "None" for projector ID allows you to operate multiple projectors concurrently. However, some projectors may not synchronize to the other projectors.

	REMOTE2	S-VIDEO1
		Y
	IN
Projector ID= 01		Projector ID= 02	Projector ID= 03

C

OUT

INPUT7

Remote Address = 03

E – 23