NEC Using On-ScreenMenu, 8-23, Seamless Switch GT6000 only, What Does This Function Do?

8. Using On-Screen Menu

Seamless Switch (GT6000 only)

1.What Does This Function Do?

This function provides a transition effect during source switch- ing.

[Before switching] [During switching] [After switching]

*The drawings show an example of how “Effect-Wipe Right” works.

2. Setting the Seamless Switch function.

2-1. Set effects and speed of the transition from source to source. Select the Advanced Menu → [Projector Options] → [Seam- less Switch].

• On/Off

Turns on or off the Seamless Switch function.

The default setting is “Off”.

• Effect

Selects one of the six effects during source switching. The default setting is “None”.

None	Displays a still image from the previously se-
	lected source while switching to another source.
Wipe Down	Displays a still image from the previously se-
Wipe Left	lected source, then performs a wipe effect in a
Wipe Up	desired direction while switching to another
Wipe Right	source.
Box In	Displays a still image from the previously se-
	lected source, then performs a “box in” effect
	while switching to another source.
Box Out	Displays a still image from the previously se-
	lected source, then performs a “box out” effect
	while switching to another source.

• Speed

Select one of the three switching speeds: Fast, Medium and Slow. The default setting is “Medium”.

• Synchronize

The default setting is “Off”.

Auto	Selecting "Off" can cause horizontal lines when a
	moving image is displayed. If you want to delete
	the lines, select "Auto". When "Auto" is selected,
	the image can be distorted for a moment immedi-
	ately after source switching.
Off	Normally set to “Off”.

2-2. Set [Last Memory] or [Direct Key].

After turning on the Seamless Switch, be sure to do either one of the following settings (1) or (2).

(1)Turn on “Last Memory” (Place a check mark in the “Last Memory” check box.)

This setting enables the Seamless Switch function while source is switching by using Source/Input (0-9) buttons on the remote control.

(2)Register signals you want to use for the Seamless Switch function in “Entry List”. In doing so, do the “Direct Key” setting.

This setting enables the Seamless Switch function while source is switching by using the CTL button and Source/ Input (0-9) buttons on the remote control.

NOTE:

•With the Seamless Switch turned on, a signal with a higher resolution than 1024 × 768 (XGA) will be displayed using NEC’s Advanced AccuBlend technol- ogy.

•When switching is performed using the Seamless Switch function between two signals with different “Picture Management" settings, the hue of the image may be changed immediately before source switching. This is because the Picture Management settings will be changed along with source switching.

8-23