Epson E02 manual 4Installation Rev. a

Page 20

remove screw

remove screw

3.Tighten the screws.

If you have removed an interface circuit board that was already installed, fix the UB-E02 using the removed screws.

4.Plug the twist pair cable into the 10BASE-T/100BASE-TX Ethernet connector of the UB-E02 until it clicks.

CAUTION:

Be sure not to connect a telephone line, display module connector, or drawer kick-out connector cable to the 10BASE-T/100BASE-TXEthernet connector of the UB-E02.

The display module connector on the TM printer cannot be used when the UB-E02 is installed.

5.Connect the power unit to the printer.

6.Turn on the printer power.

2-4Installation

Rev. A

Image 20

Contents UB-E02 Technical Reference Guide Page Rev. a Revision Information Related Documents Contents of the GuideAbout This Guide EMC and Safety Standards Applied CE MarkingFCC Compliance Statement For American Users For Canadian UsersKey to Symbols GereäuschpegelLabel Safety PrecautionsProduct Servicing Environments for Setup Utility IntroductionOperating Environments Supported Operating SystemsSupported TM Printers How to Use this Guide Installation OverviewProgramming AppendixContents Rev. a Contents Xii Contents Rev. a Supported Operating Systems Supported Network ProtocolsOther Limitations Installation Installation PrecautionsSwitch UnpackingPart Names FunctionsUB-E02 Installation 4Installation Rev. a Page 6Installation Rev. a Initializing UB-E02 UB-E02 Status Sheet Printing3 Q3. Starting up the printer takes a long time FAQ2 Q2. The self test does not operate correctly UB-E02 Technical Reference Guide 10Installation Rev. a Setting the TCP/IP protocol in Your Operating System Setting the IP AddressSetting the IP Address using Epson TMNet WinConfig Windows UB-E02 Technical Reference Guide Windows NT Windows Installing Epson TMNet WinConfig Installation EnvironmentsInstallation with Windows Setting with the Epson TMNet WinConfig UB-E02 Technical Reference Guide Page Setting the IP Address Using the arp/ping Command Example ping Epson TMNet WinConfig Functions Tool Menu Time-out setting Menu BarSearch Options Settings Printer Print server TCP/IP Password Epson TMNet WebConfig Functions Opening ScreenTCP/IP Protocol Information and Settings General Information2.2 TCP/IP Information ApipaSnmp Information 2.4 TCP/IP Setting Snmp Communication Setting Snmp IP Trap 1 Setting Snmp IP Trap 2 Setting Administrator Setting Password Setting Reset Advanced Programming Samples Method of Printing to the UB-E02 Buffer of the UB-E02Direct Printing by PORT9100 For Windows Console4Programming Samples For Linux Commands Sent to a TM Printer When the Power is On Monitoring of the ASB statusPriorities of Printing Time-out for ConnectionPrinter Operation by the UDP Commands Commands PacketsReply data 2 03-0000 Retrieving Basic Information3 03-0010 Retrieving Status Set-up data 5 03-0012 Reset4 03-0011 Forced Transmission 7 03-0016 Clearing Connection Time-Out Timer 6 03-0013 Buffer FlashProgramming Sample For Windows Console12Programming Samples For Linux Rev. a 13Programming Samples14Programming Samples Features Printer ConnectionLine Display Connection OverviewHardware Specifications Software Specifications External appearance and connector locationsBasic Communications Protocols Printing Communications ProtocolsSnmp MIB Status Inquiry and Setting ProtocolsHttp IP Address Acquisition by Dhcp Automatic IP Address Assignment ProtocolsEnpc Manual Setting IP Address Assignment by ApipaInternal Settings Item ListInternal Parameter Setting Methods Setting with Exclusive utilitySetting with Browser Setting the IP Address with arp + pingUpgrade Methods InitializingVersion Upgrading Supported protocolEnvironmental Specifications Storage ConditionsDefinitions 2Definitions Rev. a Page Epson