Kyocera KM-3650w operation manual Keeping the paper in the custody

Page 16

Paper that has already been used for printing

Very slippery paper

Very sticky paper

Very thin and soft paper

OHP Film

CAUTION

Do not use the paper with staple, or do not use such conductive paper as aluminium foil and carbon paper.

Such paper may become cause for the fire.

NOTE

(1)Print image may become light if printed on a paper of rough surface.

(2)Print image may become defective if the print paper is much curled.

(3)It will become a cause for paper jam, poor quality image or crease of paper if you use a paper that does not satisfy the specification.

(4)Do not use a paper of which surface is very special, such as thermal paper, art paper, aluminium foil, carbon paper and conductive paper.

1.6. 2 Keeping the paper in the custody

Keep the paper in the custody taking care of the following matters.

1.Do not expose the paper to the direct sunlight.

2.Keep the paper away from high humidity. (It must be less than 70%)

3.Put the paper on a flat place

4.If you keep the paper in the custody, which you have already unpacked, put it into the polyethylene bag to avoid the humidity.

1-13

Chapter 1 Before Use

Image 16
Contents KM-3650w Table of Contents Maintenance Chapter Before Use Originals Prohibited from Duplication Reference Law Prohibited items to copyFeatures Specifications GeneralPrinter part 4MIL PF4DMEScanner part LEDAppearance Front viewRear view Specifications for the Scan Original Page Rough surface Carbon paper for example Punched Before Use Specifications for the Printing Paper Papers not available to useKeeping the paper in the custody Measures against environmental condition Chapter Basic Operations Turning on the Machine Turning off the Machine Replacement of Roll Paper Page Page Page Page Replacement of Toner Cartridge Page Page Page Set of Cut Sheet Paper to the Bypass Feeder Copying Emergent Stop of Scan or Copy Dehumidifying the Roll Paper Option Chapter Error Correction Paper jam Operator Call ErrorsPaper jam in the Roll Deck. Set the roll paper correctly Page Page Paper jam in the bypass feeder. Remove the paper Page Page Paper jam in exit area. Open the cover, and remove the paper Page Page Original Jam. Open the cover, and remove the original Open errors Cover is open. Close the Cover. or Printer is starting upPage Roll Deck is open. Close the Roll Deck Close the scanner cover Set XX roll paper to the Roll Deck Other messagesSet a paper to the bypass feeder Warm Sleep Mode Toner empty. Replace the toner cartridgePower Save Mode Service Call Errors Chapter Cleaning of Each Part Scanner UnitPage Print Engine Page Operation Panel Page Page 2006 Is a trademark of Kyocera Corporation 2006.3 Rev.1.0