Kyocera KM-3650w operation manual Printer part, 4MIL PF4DME

1. 3. 2		Printer part
	Subject		Specification
	Printing method		LED Array Electro photography
	Photoreceptor		Organic Photoconductive Drum
	Print speed		60mm per second
				(Metric)	-
				(Inch)	2.6ppm/E 4.4ppm/D Landscape
	Print head		LED Array
	Resolution of print head		600dpi x 600dpi
	Print width		Maximum		914mm (36 inches)
			Minimum		297mm or 11” (Roll paper)
					210mm (Cut sheet paper)
	Print length		Maximum
				Plain paper	3600mm (36” paper)
					Or “3 x each standard length” (34” or narrower)
				Tracing	2 x each standard length
				Film	1 x each standard length
			Minimum		210mm
				NOTE
				A longer print than the above lengths is available optionally.
				(24 meters max.)
				But note that we will not guarantee the image quality or
				reliability of paper feeding if the print is longer than the above
				lengths.
	Warm up time		Shorter than 5 minutes
			(At 23oC, 60%RH, the rated voltage, and plain paper is used)
	First print time		24 seconds (D Landscape / 100% / Roll1)
	Fusing method		Heat and Pressure Rollers
	Development method		Dry type non-magnetic mono-component toner
	Media		(Recommended Media)
				Plain Paper	64 to 80g/m2 US Bond (PB-20)
				Tracing Paper	US Vellum (XV-20)
				Film	4MIL (PF4DME)
	Storage of consumables		(Toner cartridge)
				Store the cartridge within the temperature range from 0 to
				35 degrees Centigrade and within the humidity range from 10
				to 85% RH.

NOTE

The above specifications may change without notice.

1-5 Chapter 1 Before Use