FARGO electronic II manual For Users in the United States

Page 3

iv

For Users in the United States:

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

■Re-orient or relocate the receiving antenna.

■Increase the separation between the equipment and receiver.

■Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

■Consult the dealer or an experienced radio/TV technician for help.

Use of a shielded cable is required to comply with the Class A limits of Part 15 of the FCC Rules.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate and/or obtain warranty service for this equipment.

For Users in Canada:

This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on the Radio Interference Regulations of the Canadian Department of Communications.

Le present appareil numerique nÕemet pas de bruits radioelectriques depassant les limites applicables aux appareils numeriques de la class A prescrites dans le Reglement sur le brouillage radioelectrique edicte par le ministere des Communications du Canada.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Color ID Card Printer Printing History For Users in the United States Table of Contents Appendix B Interfacing Information Introduction How Your Color ID Card Printer Works Special FeaturesPage Safety Precautions Vorsicht Sicherheits- maßnahmenAvertissements Consignes de sécurité¡PRECAUCION Precauciones de seguridadPrecauzioni per la Sicurezza Cuidado Precauções de SegurançaChinese or Japanese to be keylined here Chinese or Japanese to be keylined here Arabic to be keylined here Getting Started Identifying the Parts Power About Ribbons Ribbons and CardsPage Loading Ribbon into the Printer About Cards Page Loading Cards into the Printer About Printer’s Laminator Card LaminatingAbout Overlaminates Loading the Overlaminate into the Printer Take-up Roll Applying Power Running the Self TestHooking Up the Printer Connecting the Color ID Card Printer to Your Computer Page Windows Highlight the Install Unlisted or Updated Installing the 32-Bit Print Spooler for Windows Page Setting Up Windows Printer Driver Card Size Ribbon Type Color Matching Dither Mode OverlayPanel Graphics Panel Only Split Ribbon Print Page Fast 32-bit Spooler OrientationDuplex Printing Controls Magnetics Lamination Page Supplies Required MaintenanceStandard Printhead Cleaning Expanded Printhead Cleaning Cleaning the Printer’s Case Inside Clearing a Card Jam Clearing a Ribbon Jam Cleaning the Card Feed Rollers Cleaning the Drive Roller Maintaining the Cleaning Rollers Card Input Mechanical AdjustmentsAdjusting Adjusting Internal Card GuideInternal Adjusting Card Separator Flap Card Flap Adjustment Adjusting the Laminator Top Edge Bottom Edge Trouble- shooting Symptoms printer makes strange sounds or stops printing My prints have blotches small voids in them My prints have streaks in themPage Page Print Speed Technical SpecificationsIntroduction Magnetic Stripe Encoding ModuleTrack LocationsSending Track Information ~1%JULIE ANDERSON623-85-1253? Introduction Centronics- type Parallel Interface Interfacing InformationIndex
Top Page Image Contents