FARGO electronic II manual Internal

Page 53

48

Internal

Card Guide

Card Guide Screws

Card Guides

 

 

Mounting Screws

 

2.Remove the ribbon and overlaminate rolls from the printer.

3.As you are looking inside the printer from the front, locate the Internal Card Guide on the left-hand side (the lamination side) of the printer. This guide straddles the laminatorÕs black Drive Roller.

4.Remove the single screw from the two holes residing to the immediate right of the laminatorÕs Internal Card Guide.

5.With your left hand, pull the laminatorÕs spring-

loaded Internal Card Guide toward you. If printing onto cards which are over 2.3Ó in width, pull the Internal Card Guide back behind the top-most hole (the hole furthest from the front of the printer) and re-insert the screw into this hole. Adjustment to the laminatorÕs Internal Card Guide is now complete.

6.Now, locate the Internal Card Guide on the right- hand side (the card input side) of the printer.

7.Remove the single screw from the two holes residing to the immediate right of this Internal Card Guide.

8.With your left hand, pull the spring-loaded Internal Card Guide toward you. If printing onto cards which are between 2.3Ó and 2.5Ó in width, pull the Internal Card Guide back behind the top-most hole (the hole furthest from the front of the printer) and re-insert the screw into this hole.

9.If printing onto cards between 2.5Ó and 2.6Ó in width, loosen the Internal Card GuideÕs mounting screws (shown above), slide the Card Guide assembly all the way toward the front of the printer, and retighten the screws. Then, pull the Internal Card Guide back behind the bottom-most hole (the hole closest to the front of the printer) and re-insert the screw into this hole.

Page 52 Page 54
Image 53
Page 52 Page 54
Contents Color ID Card Printer Printing History For Users in the United States Table of Contents Appendix B Interfacing Information Introduction How Your Color ID Card Printer Works Special FeaturesPage Safety Precautions Vorsicht Sicherheits- maßnahmenAvertissements Consignes de sécurité¡PRECAUCION Precauciones de seguridadPrecauzioni per la Sicurezza Cuidado Precauções de SegurançaChinese or Japanese to be keylined here Chinese or Japanese to be keylined here Arabic to be keylined here Getting Started Identifying the Parts Power About Ribbons Ribbons and CardsPage Loading Ribbon into the Printer About Cards Page Loading Cards into the Printer About Printer’s Laminator Card LaminatingAbout Overlaminates Loading the Overlaminate into the Printer Take-up Roll Hooking Up the Printer Applying PowerRunning the Self Test Connecting the Color ID Card Printer to Your Computer Page Windows Highlight the Install Unlisted or Updated Installing the 32-Bit Print Spooler for Windows Page Setting Up Windows Printer Driver Card Size Ribbon Type Color Matching Panel Graphics Dither ModeOverlay Panel Only Split Ribbon Print Page Duplex Printing Fast 32-bit SpoolerOrientation Controls Magnetics Lamination Page Supplies Required MaintenanceStandard Printhead Cleaning Expanded Printhead Cleaning Cleaning the Printer’s Case Inside Clearing a Card Jam Clearing a Ribbon Jam Cleaning the Card Feed Rollers Cleaning the Drive Roller Maintaining the Cleaning Rollers Adjusting Mechanical AdjustmentsAdjusting Internal Card Guide Card InputInternal Adjusting Card Separator Flap Card Flap Adjustment Adjusting the Laminator Top Edge Bottom Edge Trouble- shooting Symptoms printer makes strange sounds or stops printing My prints have blotches small voids in them My prints have streaks in themPage Page Print Speed Technical SpecificationsIntroduction Magnetic Stripe Encoding ModuleSending Track Information TrackLocations ~1%JULIE ANDERSON623-85-1253? Introduction Centronics- type Parallel Interface Interfacing InformationIndex
Top Page Image Contents