FARGO electronic II manual Card Flap Adjustment

Page 55

50

Card Flap
Adjustment	Card
Screws	Feed Roller
Cleaning Roller Assembly

6.As you are looking inside the printer from the front, locate the two single screws located just to the left of each end of the first Card Feed Roller. Rotate these screws to adjust the Card Separator Flap.

7.Rotate the screws clockwise to move the Card Separator Flap upward or counter clockwise to move the flap downward. If inserting thicker cards, move the Card Separator Flap downward. If inserting thinner cards, move the flap upwards.

When adjusted properly, the space between the

Card Separator Flap and the first Card Feed Roller should be approximately the same as the thickness of your card stock. To accurately view this space, look directly into the Card Hopper and locate the shaft of the Card HopperÕs first Metal Roller and the shaft of the first Card Feed Roller (see illustrations to locate these items). With the spring- loaded Card Input Tray pressed down, direct your line of sight into the Card Hopper so that the shaft of the Metal Roller appears directly in front of the shaft of the Card Feed Roller. Only when this line of sight is established can you accurately judge and adjust the position of the Card Separator Flap. Remember that the flap must always be adjusted parallel to the Card Feed Roller.

8.Once you have adjusted the Card Separator Flap to the optimum level, tighten the screws loosened in step 5 to secure the Card Separator Flap in place.

9.Adjustment to the Card Separator Flap is now complete. Replace the ribbon and cards, and shut the printerÕs top-right cover and Card Hopper Door to begin printing.

Image 55

Contents Color ID Card Printer Printing History For Users in the United States Table of Contents Appendix B Interfacing Information Introduction How Your Color ID Card Printer Works Special FeaturesPage Safety Precautions Vorsicht Sicherheits- maßnahmenAvertissements Consignes de sécurité¡PRECAUCION Precauciones de seguridadPrecauzioni per la Sicurezza Cuidado Precauções de SegurançaChinese or Japanese to be keylined here Chinese or Japanese to be keylined here Arabic to be keylined here Getting Started Identifying the Parts Power About Ribbons Ribbons and CardsPage Loading Ribbon into the Printer About Cards Page Loading Cards into the Printer About Printer’s Laminator Card LaminatingAbout Overlaminates Loading the Overlaminate into the Printer Take-up Roll Running the Self Test Applying PowerHooking Up the Printer Connecting the Color ID Card Printer to Your Computer Page Windows Highlight the Install Unlisted or Updated Installing the 32-Bit Print Spooler for Windows Page Setting Up Windows Printer Driver Card Size Ribbon Type Color Matching Overlay Dither ModePanel Graphics Panel Only Split Ribbon Print Page Orientation Fast 32-bit SpoolerDuplex Printing Controls Magnetics Lamination Page Supplies Required MaintenanceStandard Printhead Cleaning Expanded Printhead Cleaning Cleaning the Printer’s Case Inside Clearing a Card Jam Clearing a Ribbon Jam Cleaning the Card Feed Rollers Cleaning the Drive Roller Maintaining the Cleaning Rollers Card Input Mechanical AdjustmentsAdjusting Adjusting Internal Card GuideInternal Adjusting Card Separator Flap Card Flap Adjustment Adjusting the Laminator Top Edge Bottom Edge Trouble- shooting Symptoms printer makes strange sounds or stops printing My prints have blotches small voids in them My prints have streaks in themPage Page Print Speed Technical SpecificationsIntroduction Magnetic Stripe Encoding ModuleLocations TrackSending Track Information ~1%JULIE ANDERSON623-85-1253? Introduction Centronics- type Parallel Interface Interfacing InformationIndex