FARGO electronic II manual Adjusting Card Separator Flap

Page 54

C. Adjusting the

Card Separator

Flap

Adjustment to the second Internal Card Guide is now complete.

The Card Separator Flap resides inside the printer and helps prevent two cards from feeding simultaneously. This flap is adjustable to accommodate varying card thicknesses. Although the Card Separator Flap will automatically adjust to slight card thickness variations, a manual adjustment should be made in order for the printer to consistently feed single cards which vary from the standard CR-80 .030Ó card thickness. To adjust the Card Separator Flap, refer to the following steps:

1.Open the Card Hopper Door located on the right-hand side of the printerÕs exterior by grasping the top of the door and pulling straight down. Allow the door to swing completely open.

2.Remove all cards from the Card Hopper.

3.Open the top-right cover of the printer by pressing its Cover Release Button. Allow the cover to swing up and open.

4.Remove the ribbon from the printer.

5.As you are looking straight into the Card Hopper, locate the two single screws which reside in the upper corners of the back plate of the Card Hopper. You will find one screw to the right of the right Card Input Guide and one screw to the left of the left Card Input Guide. Loosen these screws.

Card Input Guides

Metal Roller

Card Input Tray

Card

Feed

Roller

Card Input

Hopper Door

49

Image 54

Contents Color ID Card Printer Printing History For Users in the United States Table of Contents Appendix B Interfacing Information How Your Color ID Card Printer Works Special Features IntroductionPage Safety Precautions Sicherheits- maßnahmen VorsichtConsignes de sécurité AvertissementsPrecauciones de seguridad ¡PRECAUCIONPrecauzioni per la Sicurezza Precauções de Segurança CuidadoChinese or Japanese to be keylined here Chinese or Japanese to be keylined here Arabic to be keylined here Getting Started Identifying the Parts Power Ribbons and Cards About RibbonsPage Loading Ribbon into the Printer About Cards Page Loading Cards into the Printer Card Laminating About Printer’s LaminatorAbout Overlaminates Loading the Overlaminate into the Printer Take-up Roll Applying Power Running the Self TestHooking Up the Printer Connecting the Color ID Card Printer to Your Computer Page Windows Highlight the Install Unlisted or Updated Installing the 32-Bit Print Spooler for Windows Page Setting Up Windows Printer Driver Card Size Ribbon Type Color Matching Dither Mode OverlayPanel Graphics Panel Only Split Ribbon Print Page Fast 32-bit Spooler OrientationDuplex Printing Controls Magnetics Lamination Page Maintenance Supplies RequiredStandard Printhead Cleaning Expanded Printhead Cleaning Cleaning the Printer’s Case Inside Clearing a Card Jam Clearing a Ribbon Jam Cleaning the Card Feed Rollers Cleaning the Drive Roller Maintaining the Cleaning Rollers Adjusting Internal Card Guide Mechanical AdjustmentsAdjusting Card InputInternal Adjusting Card Separator Flap Card Flap Adjustment Adjusting the Laminator Top Edge Bottom Edge Trouble- shooting Symptoms printer makes strange sounds or stops printing My prints have streaks in them My prints have blotches small voids in themPage Page Technical Specifications Print SpeedMagnetic Stripe Encoding Module IntroductionTrack LocationsSending Track Information ~1%JULIE ANDERSON623-85-1253? Interfacing Information Introduction Centronics- type Parallel InterfaceIndex