Kyocera KR1 manual Sites.By default the Filters is IP Filters

Page 23

Advanced > Filters > IP Filters

Filters-

Filters are used to deny or allow LAN (Local Area Network) computers from accessing the Internet.

 

The Kyocera KR1 Mobile Router can be setup to deny internal computers by their IP or MAC

 

addresses. The Kyocera KR1 Mobile Router can also block users from accessing restricted web

 

sites.By default the Filters is IP Filters.

IP Filters-

Use IP Filters to deny LAN IP addresses from accessing the Internet. You can deny specific port

 

numbers or all ports for the specific IP address.By default the IP Filters is Disabled.

IP-

The IP address of the LAN computer that is denied access to the Internet.

Port-

The single port or port range that is denied access to the Internet.

Schedule-

This is the schedule of time when the IP Filter gets enabled. By default the Schedule is Always.

Using the Configuration Menu

19

Image 23
Contents Kyocera KR1 Mobile Router User Guide Kyocera KR1 Mobile Router User Guide Table of Contents Troubleshooting Connections-Kyocera KR1 Mobile Router Back View IntroductionLEDs-Kyocera KR1 Mobile Router Front View Features Package Contents Standards-Based Technology Wireless BasicsInstallation Considerations Connect the Kyocera KR1 Wireless Router to Your Network Installation InstructionsUsing the Configuration Menu Basic Wizard No Encryption is the default as shown in the screen above Encryption setting for a more secure wireless connection Basic Wireless Security-WPA-PSK Enter the new User Name for your PC card here IP address of the LAN interface. The default IP address is Basic Dhcp Enter the name referencing the virtual service Virtual service This is the name referencing the special application Sites.By default the Filters is IP Filters Enter the name here Enter the name To the Internet. By default the DMZ is Disabled Only a minor modification should be made Kyocera KR1 Mobile Router User Guide Advanced WAN Evdo Administrator tasks from the remote Internet host Recommended Tools System Tools Firmware By default the Ddns is Disabled Tools Misc Tools Cable Test Address Displays the MAC address First page of the log Check the box next to System Log. Click Apply Status Log Log Settings #3 Status Stats Click on Help at any time, for more information Troubleshooting Double-click on Network Adapters Select the Support tab. The IP Address will be displayed Forgot my encryption key. What should I do? What is VPN? What can I do if my Ethernet cable does not work properly? Technical Support Technical SupportPptp Technical SpecificationsExt. Power Supply DC 5V, 3.0A Consumer Limited Warranty USA only
Related manuals
Manual 61 pages 12.09 Kb