NEC M7, M5 manual Removing the Main Board, Disconnecting main board and LED board

Page 23

Removing the Main Board

To remove the main board, first remove the Bottom Cover (See Removing the Bottom

Cover) then perform the following steps:

1. Disconnect the LED Board as shown in Fig. 37

Fig. 37 Disconnecting main board and LED board

2.Carefully separate the Main Board assembly from the top cover as shown in Fig. 38

Fig. 38 Lifting up the Main Board assembly

Packard Bell EasyNote M5/M7 Disassembly Manual

23

Image 23

Contents Packard Bell EasyNote M5 / M7 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage =M2.5x7 black =M2.5x5 black Removing the BatteryRemoving the Hard Disk Drive M3x4 silver Disconnecting the hard disk driveM2.5x5 black Removing the Optical Disk DriveM2x2.5 silver Removing the KeyboardUnlock the Keyboard Removing the screw retaining the memory module slot cover Removing the Memory ModuleRemoving the LCD Module Disconnecting LCD ConnectorM3x6 silver Removing the 15 LCD Panel=M2x4 black =M2.5x7 black Screws on the LCD Module=M2.5x7 black =M2x4 black Removing the LCD panel screwsM2x3.5 black Removing the 14 LCD PanelUnscrew all screws as shown in Fig =M2x4.5 Silver =M2x4 black =M2.5x7 black Removing the side rubber coversM2x3.5 black M2.5x5 black Removing the CPUM3x21 Removing the heat sinkRemoving the Quick Key Board Removing the Bottom Cover=M2.5x7 black =M2.5x5 black =M2.5x3.5 Black =Hex2.5x10 Removing screws on bottom of the systemRemoving the Bottom Cover Removing the Main Board Disconnecting main board and LED boardM2.5x7 black M2x4.5 black Removing the MDC Modem ModuleRemoving the Wlan Module Removing the Wlan ModuleM2x3 black M2x3.5 black Removing the Speaker AssemblyRemoving the Touch Pad Screws Dipswitch SettingsEasyNote M5/M7 Disassembly Manual