NEC manual EasyNote M5/M7 Disassembly Manual

Page 28

Notice

The information in this guide is subject to change without notice.

This guide contains information protected by copyright. No part of this guide may be photocopied or reproduced in any form or by any means without prior written consent from NEC Computers International BV.

NEC COMPUTERS INTERNATIONAL BV SHALL NOT BE LIABLE FOR TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN; NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL.

Copyright © 2003 NEC Computers International BV. All rights reserved.

NEC is a trademark of NEC Computers International BV.

The names of actual companies and products mentioned herein may be trademarks and/or registered trademarks of their respective owners.

EasyNote M5/M7 Disassembly Manual

Author: Allen Koay and Bensoussan Daniel

Edition: September 2003

Document Part Number:

Version: 2.0

NEC

A division of NEC Computers International BV

Packard Bell EasyNote M5/M7 Disassembly Manual

28

Image 28
Contents Packard Bell EasyNote M5 / M7 Disassembly Manual Table of contents Disassembly Instructions Reassembly InstructionsOverview Technician NotesHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Hard Disk Drive Removing the Battery=M2.5x7 black =M2.5x5 black Disconnecting the hard disk drive M3x4 silverRemoving the Optical Disk Drive M2.5x5 blackRemoving the Keyboard M2x2.5 silverUnlock the Keyboard Removing the Memory Module Removing the screw retaining the memory module slot coverDisconnecting LCD Connector Removing the LCD ModuleRemoving the 15 LCD Panel M3x6 silverScrews on the LCD Module =M2x4 black =M2.5x7 blackRemoving the LCD panel screws =M2.5x7 black =M2x4 blackRemoving the 14 LCD Panel M2x3.5 blackUnscrew all screws as shown in Fig Removing the side rubber covers =M2x4.5 Silver =M2x4 black =M2.5x7 blackRemoving the CPU M2x3.5 black M2.5x5 blackRemoving the heat sink M3x21Removing the Bottom Cover Removing the Quick Key BoardRemoving screws on bottom of the system =M2.5x7 black =M2.5x5 black =M2.5x3.5 Black =Hex2.5x10Removing the Bottom Cover Disconnecting main board and LED board Removing the Main BoardRemoving the MDC Modem Module M2.5x7 black M2x4.5 blackRemoving the Wlan Module Removing the Wlan ModuleRemoving the Touch Pad Removing the Speaker AssemblyM2x3 black M2x3.5 black Dipswitch Settings ScrewsEasyNote M5/M7 Disassembly Manual