NEC M7, M5 manual Removing the Optical Disk Drive, M2.5x5 black

Page 7

Removing the Optical Disk Drive

To remove the ODD, first remove the battery (see Removing the Battery), then the HDD Cover (see Removing the Hard Disk Drive), then perform the following steps:

1. Remove the screws retaining the optical drive connector as shown in Fig. 5

Fig. 5 Releasing the optical drive

2.Push the metal plate in the HDD compartment in order to disconnect the optical drive out from the base unit as shown in Fig. 6

Fig. 6 Removing the optical drive

Packard Bell EasyNote M5/M7 Disassembly Manual

M2.5x5 black

7

Image 7

Contents Packard Bell EasyNote M5 / M7 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewHazardous Voltage Power Supply UnitAvoid Electrostatic Discharge Removing the Hard Disk Drive Removing the Battery=M2.5x7 black =M2.5x5 black M3x4 silver Disconnecting the hard disk driveM2.5x5 black Removing the Optical Disk DriveM2x2.5 silver Removing the KeyboardUnlock the Keyboard Removing the screw retaining the memory module slot cover Removing the Memory ModuleRemoving the LCD Module Disconnecting LCD ConnectorM3x6 silver Removing the 15 LCD Panel=M2x4 black =M2.5x7 black Screws on the LCD Module=M2.5x7 black =M2x4 black Removing the LCD panel screwsM2x3.5 black Removing the 14 LCD PanelUnscrew all screws as shown in Fig =M2x4.5 Silver =M2x4 black =M2.5x7 black Removing the side rubber coversM2x3.5 black M2.5x5 black Removing the CPUM3x21 Removing the heat sinkRemoving the Quick Key Board Removing the Bottom Cover=M2.5x7 black =M2.5x5 black =M2.5x3.5 Black =Hex2.5x10 Removing screws on bottom of the systemRemoving the Bottom Cover Removing the Main Board Disconnecting main board and LED boardM2.5x7 black M2x4.5 black Removing the MDC Modem ModuleRemoving the Wlan Module Removing the Wlan ModuleRemoving the Touch Pad Removing the Speaker AssemblyM2x3 black M2x3.5 black Screws Dipswitch SettingsEasyNote M5/M7 Disassembly Manual