NEC M7, M5 manual Removing the LCD Module, Disconnecting LCD Connector

Page 11

Removing the LCD Module

To remove the LCD Module, first remove the Battery (see Removing the Battery), remove the Keyboard (see Removing the Keyboard) then perform the following steps:

1. Disconnect the LCD connectors as shown in Fig. 13

Fig. 13 Disconnecting LCD Connector

2.Carefully pull the LCD cable upward to release both Hinge Covers as shown in Fig. 14

Fig. 14 Removing the Hinge Covers

Packard Bell EasyNote M5/M7 Disassembly Manual

11

Image 11

Contents Packard Bell EasyNote M5 / M7 Disassembly Manual Table of contents Technician Notes Disassembly InstructionsReassembly Instructions OverviewAvoid Electrostatic Discharge Power Supply UnitHazardous Voltage =M2.5x7 black =M2.5x5 black Removing the BatteryRemoving the Hard Disk Drive M3x4 silver Disconnecting the hard disk driveM2.5x5 black Removing the Optical Disk DriveM2x2.5 silver Removing the KeyboardUnlock the Keyboard Removing the screw retaining the memory module slot cover Removing the Memory ModuleRemoving the LCD Module Disconnecting LCD ConnectorM3x6 silver Removing the 15 LCD Panel=M2x4 black =M2.5x7 black Screws on the LCD Module=M2.5x7 black =M2x4 black Removing the LCD panel screwsM2x3.5 black Removing the 14 LCD PanelUnscrew all screws as shown in Fig =M2x4.5 Silver =M2x4 black =M2.5x7 black Removing the side rubber coversM2x3.5 black M2.5x5 black Removing the CPUM3x21 Removing the heat sinkRemoving the Quick Key Board Removing the Bottom Cover=M2.5x7 black =M2.5x5 black =M2.5x3.5 Black =Hex2.5x10 Removing screws on bottom of the systemRemoving the Bottom Cover Removing the Main Board Disconnecting main board and LED boardM2.5x7 black M2x4.5 black Removing the MDC Modem ModuleRemoving the Wlan Module Removing the Wlan ModuleM2x3 black M2x3.5 black Removing the Speaker AssemblyRemoving the Touch Pad Screws Dipswitch SettingsEasyNote M5/M7 Disassembly Manual