Oki 3100e manual Telnet, Items that can be set

setup, in some cases, “Security Information” dialogue is displayed every time the size is changed. If this occurs, uncheck the check box of “Show This Alert Next Time” of “Security Information” dialogue.

Telnet

You can set up this network card using the Telnet in the network environment where the TCP/IP protocol is used.

Note 1: You cannot make the NetWare server side s e t t i n g s w i t h T e l n e t . P l e a s e u s e PCONSOLE, etc., for that.

Note 2: Telnet and Web cannot be connected at the same time.

Note 3: Maximum of two Telnet sessions can be connected.

Items that can be set

The following items can be set in Telnet. To change the settings, you must log in from [root] using the administrator’s account.

Category	Item	Meaning		Range
	TCP/IP	TCP/IP Enable/Disable	Enable/Disable
Protocol	NetWare	NetWare Enable/Disable	Enable/Disable
	EtherTalk	EtherTalk Enable/Disable	Enable/Disable
	NetBEUI	NetBEUI Enable/Disable	Enable/Disable
	IP BYTE 1-4	IP Address	0	- 255
IP	SM BYTE 1-4	Subnet Mask	0	- 255
	GW BYTE 1-4	Default Gateway	0	- 255
NetWare Common	NetWare Print Mode	Select operation in print mode	Auto/Q-Server/R-Printer
	NetWare Print Server Name	Set own print server name	1	- 48 characters, default OKIDATA. (MAC address last
Q-Server			6 characters).
	Polling Rate	Polling cycle	1	- 60 sec, default 5 sec

44 OkiLAN 3100e Network Card