Primera Technology LX400 user manual Tear Off Position

Page 46

TOC

INDEX

Tear Off Position

If Output Mode (described later in this section) is set to Present, the printer will present your labels over the Tear Bar for easy removal. This tear off position is set at the factory. If fine tuning is needed to align the break in your label stock over the Tear Bar, increase this setting to eject the label further; decrease this setting to eject the label stock less. The unit of measure is 0.1 mm.

Cut Position

If a label cutter attachment is connected to the printer you can fine tune the cut position between the labels. Increase this value to move the label further out before the cut; decrease this value to eject the label stock less before the cut.

Left Margin Offset

This will be factory calibrated. If fine tuning is needed, increase this setting to move the image right on the label; decrease this setting to move the image to the left on the label. The unit of measure is 0.1mm.

Top of Form (TOF)

This setting allows you to fine tune the print starting position on your label stock. This will be factory calibrated. If fine tuning is needed, increase this value to move the image down on the label. Decrease this value to move the image up the label. The unit of measure is 0.1mm.

Click the Test Offsets button to send a test print to the printer that will help you adjust the TOF and Left Margin Offset. The printer will print the pattern shown. Adjust the values so that both black bars print on the label with no white space on the label and no ink on the liner.

+-

LEFT OFFSET

(10 units)

TOF

1.0 mm

+

-

42Printing Using a Macintosh

Page 45 Page 47
Image 46
Page 45 Page 47
Contents Color Label Printer All rights reservedPrinting History Table of Contents Interactive Feature Thank YOU… Choosing a Good LocationUnpacking and Inspection Starter roll of high gloss label stockIdentifying the Parts Minimum PC Specifications Computer SpecificationsMinimum Macintosh Specifications Installing the PC Software Installing the MAC SoftwareConnecting the USB Cable / Installing the Printer Driver Connecting PowerIf you are using a PC If you are using Macintosh Installing Label Stock Stock Guide Rollers Adjusting the Label Stock TOF TOP of Form Sensor Circular Labels Through Hole LabelsUsing FAN-FOLD Label Stock If using a Mac Installing the INK CartridgeIf using a PC For Macintosh and PCAligning the INK Cartridge TOC Index Using Nicelabel Creating a labelTOC Index TOC Index TOC Index TOC Index TOC Index Creating Barcodes in Nicelabel RSS TOC Index Printer Driver Settings PC To find Driver SettingsPaper Size Portrait LandscapeColor Matching Ink SaturationClean/Change Cartridge & Check Ink Levels Clean/PurgeChange Cartridge Details/Print CounterOutput Mode Enable Bi-di PrintingTop of Form TOF Cut PositionPrinting Using a Macintosh Printing on a MAC from Adobe IllustratorTOC Index TOC Index TOC Index TOC Index Creating Barcodes on a MAC Printing from Other ApplicationsPrinter Driver Settings MAC Color Type Intensity Config. Utility Clean CartridgeLabel Offsets Tear Off Position Sensor Type Solving Registration Problems Image is Vertically OffsetImage is printing horizontally offset TOC Index Creating a Full Bleed Print Cleaning the Printer Clearing a Label JAMTechnical Support Cleaning the INK CartridgeSource Location Label and Roll Specifications Roll Specifications IndexIndicator Lights Print ResolutionsAccessories Power RequirementsIndex
Top Page Image Contents