Philips MGD203, MGD403 user manual SUB Video H/H+V

11 ENGLISH

Connection to the computer

	figure 3
figure 2

D-SUB

VIDEO H/H+V V

1.Connect the male plug of the mini D-Sub 15 pins cable (optional) to the D-SUBinput connector at the rear of the monitor (see figure 2).

2.(Alternative) Connect the BNC connectors (VIDEO/H/V) of the video cable to thesocket on the back of the monitor as shown in figure 3. In this configuration, the three guns will be automatically ‘locked’ (the monitor is driven as ‘mono- chrome’).

RGB H/H+V V

DAISY CHAIN

Important !

to prevent bad connection and to ensure a proper fit, tighten the thumbscrews.

3.(Alternative) Connect the BNC connectors (R/G/B/H/V) of the video cable to the socket as in § 2. (see figure 4). In this configuration, the guns are driven inde- pentently (the monitor is seen as ‘colour’).

4.If you use some monitors in Daisy Chain configuration, the units shall be con- nected each other as shown in figure 5.

5.Connect the other end of the video cable to the VIDEO OUTPUT of your PC (with high resolution graphic card or usual VGA graphic card).

Note: The monitor automatically recognizes the connected input.

The 15 pins D-Sub interface cable complies with VESA DDC1/2B standard.