How to connect a plug

APPENDIX 5

WARNING - THIS APPLIANCE MUST BE EARTH GROUNDED IMPORTANT (information for UK only)

This apparatus is supplied with an approved moulded 13A plug. To change a fuse in this type of plug proceed as follow:

1.Remove Fuse cover and fuse.

2.Fit new fuse which should be a BS 1362 5A, A.S.T.A. or BSI approve type.

3.Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate 3-pin plug fitted in its place.

If the main plug contains a fuse, this should have a value of 5A. If a plug without a fuse is used, the fuse at the distribution board should be not greater then 5A.

Note: the severed plug must be destroyed to avoid a possible shock hazard should it be inserted into a 13A socket elsewhere.

The wires in the mains lead are colored in accordance with the following code:

BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”)

GREEN & YELLOW- “EARTH GROUND” (“E”)

1.The GREEN & YELLOW wire must be connected to the terminal in the plug which is marked with the

letter “E” or by the Earth symbol

colored GREEN or GREEN & YELLOW.

2.The BLUE wire must be connected to the terminal which is marked with the letter “N” or colored

BLACK.

3.The BROWN wire must be connected to the termi- nal which is marked with the letter “L” or colored RED.

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the three wires.