23 | ENGLISH |
|
|
´OSD POSITION
This function allows to move the OSD Menu window at the desired position on the screen.
LOCAL MENU
SEL EXIT - +
|
|
LIGHT BAR | ON |
OSD REVERSE |
|
OSD POSITION |
|
First “SELECT” key press will change the message ‘OSD POSITION’ to ‘OSD UP/DOWN’ (blinking) message, indicating that the function is active, press + / - keys to move up/down the window.
Next “SELECT” key press saves previous changes and turns the message ‘OSD UP/DOWN’ (blinking) to ‘OSD LEFT/RIGHT’ (blinking) mes- sage, indicating that the function is active, press
Further “SELECT” key press saves previous changes and turns the message ‘OSD LEFT/RIGHT’ (blinking) to ‘OSD POSITION’ message, (non blinking).
At this point all the changes in OSD window position are permanently stored
If pressing the “EXIT” key at any time, when the message is blinking, last change in the new OSD position is only temporary saved in memory. In this case if the monitor is switched OFF, the “temporary saved” change is lost.
´SHOW CONFIGURATION
This function is intended to display monitor firmware release, accumulated operating hours, selected video channel Hor. & Vert. frequencies on the screen window:
LOCAL MENU
SEL EXIT - +
LIGHT BAR
OSD REVERSE
SHOW CONFIG.
Pressing the “SELECT” key, the Local Menu disappears and a new window (see below) appears. This window contains information about unit. Pressing “SELECT” key again this windows disappears and the Local Menu is displayed.
SEL EXIT
1.00 | |
WORK. HRS. | 12345 |
CHANNEL NUM. 11 | |
HOR. | 31.5 KHz |
VERT. | 70.0 Hz |
Note: | The useful range for Working Hours is: 0 to 99.999 |
| Channel number is the stored timing presenty recognized by the monitor. |