Net 1Card IB 2/15/00 12:18 PM Page 20
COMMERCIAL SETTING
FRONT KEYPAD allows you to enable or disable the buttons on the front of the TV. The default setting is “ON.” “CABLE” allows you to select between the cable
“YES” or “NO.” The default is “YES.”
BEGIN
If not already in the “COMMERCIAL SET- TINGS” menu, press the A button on the remote con- trol. Then press the ▼ button to highlight “FRONT KEYPAD.”
Press the – (◀) or + (♣) button to select “OFF” or “ON.”
When finished, press the ▼ button to highlight “CABLE.” Press the – (◀) or + (♣) button to select “YES” or “NO.” Cable should be set to the same setting as under the TV's “SETUP MENU.” For example, if the “SETUP MENU is set to “CABLE YES,” then the setup here should be “CABLE YES.” See page 33 for TV setup details. (Note: the cable setting of a Transmitter TV will override the setting of a Receiver TV whenever a channel is tuned.)
When finished, press the ▼ button to highlight “EXIT.” Then press the “M” button. Or you can exit by simply pressing the RECALL button when you’re done.
|
|
|
|
|
|
|
| COMMERCIAL SETTINGS |
|
| |||
| MODE | COMMERCIAL |
|
| ||
| CONTROL MODE TRANSMIT |
|
| |||
| FRONT KEYPAD |
| ON |
|
| |
| CABLE |
| YES |
|
| |
| EXIT MENU |
|
|
|
| |
| – FOR OFF / + FOR ON |
|
|
| ||
|
|
|
|
| ||
|
|
| COMMERCIAL SETTINGS | |||
|
|
| MODE |
| COMMERCIAL | |
|
|
| CONTROL MODE | TRANSMIT | ||
|
|
| FRONT KEYPAD | ON | ||
|
|
| CABLE |
|
| YES |
|
|
| EXIT MENU |
|
– FOR NO / + FOR YES
20
RECEIVER CONTROL
Once you have completed your general selections under the Commercial Settings menu, you must
make specific selections. These specifics depend on whether you set up the TV to “RECEIVE,” “TRANS- MIT,” or “FACTORY.”Since “RECEIVE” is the default setting and since almost all the TVs in the Net1Card net- work with be “RECEIVErs,”those specific selections are explained first.
BEGIN
If not already in the “RECEIVER CONTROL” menu, press the D button on the remote control. “RCVR GROUP IDS” should be highlighted. Receiver Group IDs allows you to group TVs. That way, you can send a message only to a group or groups of TVs and not all the TVs in the Net1Card network.
Press the Number buttons 1 - 8 to select which group or groups you want this particular TV to belong to. Each Receiver TV in the Net1Card network can belong to up to eight groups. To remove a TV from a group, simply press that Number button again.
For example, if you place a TV in groups 1, 4, 5, and 8, press the 1, 4, 5, and 8 Number buttons. If you should then want to remove the TV from the group 5, press the 5 button again. The TV is now is groups 1, 4, and 8 (as pictured below).
When finished, press the ▼ button to highlight “RCVR SET ID.”
RECEIVER CONTROL
RCVR GROUP IDS 1- - 4 - - - 8
RCVR SET ID | 0 |
EXIT MENU |
|
DIGITS TOGGLE GROUP IDS
21