Net 1Card IB 2/15/00 12:17 PM Page 12
CABLE TV HOOKUP
Your Cable TV input into your home may be a single (75 ohm) cable, or a Converter
Box installation. In either case the connection to the TV is very easy. Just put the threaded end of the cable signal to the TV's antenna plug and screw it down tight.
BEGIN
If your Cable TV signal is a single round
cable (75 ohm) then you're ready to connect to the TV.
If you have a Cable TV Converter Box:
Connect the Cable TV signal to the Cable Signal IN(put) plug on the Converter.
Connect the Cable TV cable to the RF IN plug on the TV.
If you have a Cable TV Converter Box:
Back of TV
Cable TV Company
Round Cable
75Ω Ohm
IN | OUT |
|
Cable TV Converter Box
Connection
CLONE | 2 |
|
|
|
PORT | DIO | VIDEO | AUDIO | |
|
RF IN
Net1Card
Jack Panel
1
Connect the OUT(put) plug from the Converter to the RF IN plug on the TV (connecting cable sup- plied with the Converter).
OPTIONAL VCR HOOKUP
Outdoor VHF/UHF
300 to 75Ω Ohm
SMART HELP
Remember, set the TV to the “Cable TV
Antenna
Adapter1
Round Cable
75Ω Supplied
with VCR
Mode.” Then, to select only the channel numbers on your Cable system see “Auto Program” (refer to page 34 for both features).
If you use a Cable Converter box, set the TV to the same channel as the converter's CH 3/4 switch (on the rear of the converter.)
12
OR
IN FROM ANT. | OUT TO TV |
Cable TV signal
VCR
CLONE |
|
PORT | |
| |
RF IN |
|
| Net1Card | 2 |
Back of TV | Jack Panel | |
| ||
|
|
13