CHAPTER 5: COMPUTER TERMINAL OPERATIONS
5.Computer terminal operations
5.1The Console menu
Each appliance can be configured at the appliance level through the Console menu interface accessed through the configuration port on the rear of the appliance. All terminal commands are accessed through a terminal or computer running terminal emulation software. This is not the best method for setting options for the appliance. The preferred method is to make all configuration settings in the ServSelect IP VM Software. See the ServSelect IP VM Software Installation and User’s Guide for more information.
Network configuration
To configure network settings using the Console menu, complete the following steps:
1.When you turn on the appliance, the appliance initializes for approximately one minute. After it completes initialization, press any key on the terminal or on the com- puter running the terminal emulation software to access the Console menu interface. The terminal can be connected at any time, even when the appliance is already turned on.
2.The Console Main menu opens. Type 1 and press Enter for the Network Configura- tion option. The Network Configuration menu opens.
3.Type 1 and press Enter to set the network speed. You should set the connection man- ually without relying on the auto negotiate feature. After pressing Enter, you are returned to the Network Configuration menu.
4.Type 2 and press Enter to specify whether you are using a static or Dynamic Host Configuration Protocol (DHCP) address. A static IP address can be used to provide a
5.Select the remaining options from the Network Configuration menu to finish the con- figuration of the appliance with an IP address, netmask, default gateway, and ping response.
6.Type 0 (zero) and press Enter to return to the Console Main menu. The appliance will then reboot.
Other Console Main menu options
Besides the Network Configuration option, the Console Main menu of the appliance has the following menu items: Firmware Management, Enable Debug Messages, Restore Factory Defaults, Reset Appliance, and Exit. Each is discussed in the following section.
Firmware Management
This menu contains the FLASH Download selection. For more information, see “Appendix A” beginning on page 45.
43