Black Box SW591C, SW590A-R2 manual Connecting and Powering Up the COS-II

Page 17

3.9. Connecting and Powering Up the COS-II

Once you have configured the internal switches and jumpers, you can connect your devices and the wallmounted power jack to the COS-II. Before you begin, you might wish to check the settings of all the DIP switches again, to make sure you have set them correctly.

To prepare the COS-II:

1.Make sure that SWA 8 is set to OFF, that is, to normal operation.

2.Insert the 4-pin power-supply plug in the power- supply socket (at J1) on the COS-II circuit board.

CHAPTER 3: Installation

3.Slide the cover back onto the base of the COS-II, and secure it with the screws.

4.Connect the device cables to the ports.

5.Plug the wallmounted power supply into a standard AC line.

Before you use the COS-II, you might wish to familiarize yourself with the indicators, reset button, and self-tests available. Chapter 4 explains these features.

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Code Operated Switch II 4-Port Expansion Board Code Operated Switch Contents Memory 8K buffer Enclosure Steel SpecificationsIntroduction Introduction InstallationSetting the DIP switches Installation Functions and Arrangement of the Switch BanksBank Assignments Configuring Ports with the Individual Port Switch BanksTo Set This Mode Timeout SettingSet SWF To Set a PauseLSB MSB Ascii LSB MSB Ascii Ctrl HEX LSB 128 174 Sending or Suppressing Breaks ForSelf-Test Function Signal direction Configuring Ports for DTE or DCEMaster Slave Leads passed DTE Port DCE PortConnecting and Powering Up the COS-II Text Mode Signaling a LockGraphics Mode OperationSelf-Tests IndicatorsFront-Panel Button All Tests Serial Port TestInterrupt Test Quick Reference Guide Individual Port Switch Bank SettingsSettings for Switch Option F System Switch Options Available through Position Park Drive Lawrence, PA 15055-1018 724-746-5500 Fax
Top Page Image Contents