Indicators, Front-Panel Button, Self-Tests

4.6. Indicators

The front panel of the Switch contains 10 LEDs. The Power LED, at the extreme right, will glow steadily when power is on. The Lockout LED, a green LED at the extreme left, will light when the unit is in lockout.

Each of the eight port LEDs, numbered 0 through 7, will respond to the action of the COS II. When the master port is switched to one of the slaves, the corresponding LED will glow continuously.

4.7. Front-Panel Button

The reset button is located on the front panel of the COS-II. After you change one of the DIP switches, you must reset the COS-II either by pressing the button or by disconnecting power from the unit.

4.8. Self-Tests

The COS-II can diagnose a variety of conditions with an array of self-tests. To configure the switch for a self-test, set the eighth switch of DIP Switch A to ON.

To run a test, follow these steps:

1. Set SWA 8 (the eighth DIP switch of Bank A) to

ON.2. Set the master port to DCE with a shunt

jumper.

3.Set your terminal for 9600-bps operation, with 1 stop bit and no parity.

4.Power the unit.

This message will appear on your screen:

If you select R, the COS II will run any of the tests

CODE OPERATED SWITCH II SELF TEST

RUN TESTS (R)EPEATEDLY OR (O)NCE

you request again and again, until you press the reset button.

If you select “O,” you get the message:

CHAPTER 4: Operation

Explanations and screens for all of these tests are

WHICH TESTS SHOULD BE RUN (R)AM TEST

(L)ED TEST

(D)IP SWITCH TEST

(S)ERIAL PORT TEST

(I)NTERRUPT TEST (A)LL TESTS

given below.

RAM Test

RAM TEST 8K RAM IS GOOD

The RAM test checks the internal memory of the Switch by writing an internal test pattern, and then reading it for accuracy.

LED Test

LED TEST IN PROGRESS, ALL LEDS SHOULD TURN ON AND

OFF. PRESS ANY KEY TO EXIT.

The LED Test checks the LEDs by turning them all off, then on one at a time, then all on, then off one at a time. This test tells you if the LEDs are working normally or whether any are shorted.

DIP Switch Test

DIP SWITCH TEST (MAIN BOARD) HIT ANY KEY TO GO TO NEXT TEST

SWITCHES ARE DISPLAYED IN BINARY (0=OFF, 1=ON)

SWD	SWE	SWF	SWG
00010001	00100100	10001000	01010101

The DIP Switch Test reads the switches and displays their settings on the screen. This test tells you whether the switches and associated circuitry are operating normally and are set up to your specifications. The settings will be displayed on screen continuously until a key is pressed. When you press any key, the box will check the settings of the Expansion Board switches. If you haven’t installed a Board, disregard the reading.

EXPANSION BOARD IS INSTALLED

DIP SWITCH TEST (EXPANSION BOARD) HIT ANY KEY TO GO TO NEXT TEST

SWITCHES ARE DISPLAYED IN BINARY (0=OFF, 1=ON)

SWH	SWI	SWJ	SWK
00010001	00100100	10001000	01010101