CHAPTER 5: Utility Software
5.2 GETW95C Program
The GETW95C.EXE program is provided on the Utility diskette to allow the operator to get configuration information and will display the resources assigned to the Adapter by Windows 95/98. The CEM5250.VXD driver must have been installed prior to executing this program. The CEM5250.VXD driver is normally installed automatically by Windows 95/98 when the Adapter Card is first installed in the system.
GETW95C is a DOS program for Windows 95/98 and can be executed by selecting the Start icon, then Run. Enter the following at the prompt and then select OK. The following example assumes the default installation directory (5250CARD).
C:\5250CARD\GETW95C
A DOS window will be opened and the program will execute showing the results. The following example shows the results of executing the GETW95C program. The values for the Memory Segment, I/O Port, and IRQ fields will contain the information passed by Windows 95/98. The values in this example may not be the same as observed on your system.
NOTE
If the “Memory Segment” or “V86 Memory Segment” indicates 0000, you have a memory conflict and should refer to Appendix A.
Get W95 Configuration
Version 2.05
The VxD Version is 2.03.
Adapter type is 5250 PCI.
Memory Segment is DC00.
V86 Memory Segment is DC00.
Memory Size is 0x2000 bytes.
I/O Port is 118.
IRQ is 12.
25