SYSGEN AND
Performing a full sysgen
Use the information given below when performing a full sysgen.
When to use a full sysgen In the full sysgen procedure, all system disks are formatted and the operating system software is installed on the system disks. A full sysgen is normally performed in the following situations:
•
•
•
•
A new system is installed
A system disk is replaced
Read errors or other disk problems have occurred
When required for a specific system or patch.
Note: When performing an offline (tape) sysgen, make sure the system is offline.
Backing up user files It is important to back up all user files.
Caution: If the disk being formatted contains user files, be sure to back up those files before formatting because they will be deleted from the disk.
Sysgen media A full sysgen can be performed from tape, cartridge, or host. The
Choosing a format command
Table
Table
FORMAT command | ERASE command |
|
|
• Deletes all files except | • Saves both the MBAIS and |
the MBAIS file | bad block files. |
• Performs a sector check | • Does not perform a new |
• Flags any new bad block | sector check. |
| |
areas. |
|
|
|
You must use when: | Use if you are confident of your |
• Replacing a system disk | system disk integrity. |
| |
• Installing an additional |
|
disk into the system |
|
|
|
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE |