Xerox 96/4635/180 IPS manual Checking and unloading high-capacity stacker HCS bins

OUTPUT TRAYS AND BINS

Checking and unloading high-capacity stacker (HCS) bins

The 4635 and 180 IPS printers can have up to four high-capacity stacker (HCS) bins; the 96 IPS can have up to two. Each high- capacity tray holds 2500 sheets of 20lb or 80 gsm paper. (Refer to your Xerox DocuPrint 96/4635/180 System Overview Guide for additional information on the high-capacity stacker bins.)

Note: If you use large paper sizes such as A3 or 11 x 17 inch, the stacker may hold less than 2500 sheets. This is to ensure that the stack is at a safe weight for lifting and unloading by the operator.

•

•

•

You can lower, pull out, and unload any bin not currently in use, without interrupting printing, as long as another HCS is ready to receive paper.

If you select a bin that is in use, the printer begins stacking in the next defined high-capacity stacker bin if it is available. If no stacker bin is available, printing stops.

Once a sheet is delivered to a stacker bin, each subsequent sheet must be within 25 mm (approximately 1 inch) of length and width of the first sheet.

Unloading a stacker bin To unload a stacker bin:

1.Select a bin for unloading by pressing the Bin Unload button on the bin control panel. (You can also select the bin for unloading through the printer mimic of the printer control console.)

Once a bin is selected, the bin elevator lowers and the bin cannot be used until it is emptied completely. When the bin elevator stops in the down position, the Ready to Unload indicator lights.

2-2 XEROX DOCUPRINT 96/4635/180 IPS GUIDE TO PERFORMING ROUTINE MAINTENANCE