Xerox 92C IPS manual Default Ipds Bin pull-down menu

SETTING THE SYSTEM CONFIGURATION

2. Make any desired changes in the fields described below.

•

•

Bin Selection Mode — Specifies how the IPS will determine the bin to which the job will be delivered.

The option buttons are:

—Use Default Bin — Output will be delivered to the bin you designate from the Default Bin Number pull-down menu.

—Allow Host Control — The host handles bin selection, and the system uses the bin you selected to correspond to the IPDS Bin number.

Note: If you are enabling DFA, select “Allow Host Control” for the bin selection mode.

Default IPDS Bin — Specifies the number for the bin to which output will be delivered if “Use Default Bin” is selected from the Bin Selection Mode menu, or if a bin number is not specified by a job on the host.

Note: Output is delivered to the default bin if one of the following conditions applies:

—“Use Default Bin” is selected as the Bin Selection Mode.

—“Allow Host Control” is selected as the Bin Selection Mode, but there is no OUTBIN statement for the host.

—“Allow Host Control” is selected as the Bin Selection Mode, but the OUTBIN specified is greater than the

number of stackers.

Figure 4-41.Default IPDS Bin pull-down menu

•

•

Note: The IPDS Bin 1 row is set to Sample Tray, and cannot be changed. If you want your output to be delivered to the stacker trays, you must select something other than Bin 1 for the Default Bin Number.

(DFA systems only) Check the “Finishing” box then click the Finishing Attributes button to specify the finishing attributes. Refer to “Specifying finishing attributes” later in this section.

(Systems with a stitcher only) Check the “Stitching” box then click the Stitching Attributes button to specify the finishing attributes. Refer to “Specifying stitching attributes” later in this section.

4-56 XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM