Xerox XA7-19i manual Installing Your LCD Monitor

Page 11

Introduction

Installing Your LCD Monitor

Follow the instructions below to set up and install the monitor.

1The package contains:

1.Display unit

2.Stand

DISPLAY UNIT

STAND

2Cover an even stable surface with a soft cloth. Place the unit face-down on the cloth. Fit the stand onto the bottom of the display unit as shown.

3 Use a coin to tighten the screw on	4
the bottom of the stand until the

screw is ﬁrmly ﬁxed in place.

10	Xerox© LCD Monitor User’s Manual

Image 11

Contents Page 2004 by Xerox Corporation. All rights reserved Introduction Table of ContentsInstallation Federal Communications Commission FCC StatementENGLISH Federal Communications Commission FCC StatementWarnings Important Safety InstructionsDo not touch the power cord and antenna cable during lightning d. The product has been dropped or damaged a. The power cord or plug is damagedb. Liquid is spilled into the product c. An object falls onto or into the product1 Introduction FeaturesPower cord specification H05 VV-F 3G 0.75mm2 Package Contents2 DOWN/UP 5 POWERFront View and Controls 1 MENUInstalling Your LCD Monitor Method 1 Analog D-SUB Connection 2 InstallationConnecting Your LCD Monitor to a Computer 2 Connect to the DVI port Method 2 DigitalDVI ConnectionPOWER/ button Using Your LCD Monitor5o 20o EXIT Using the OSD Menu3 OSD MENU Contrast PhaseThe OSD Options BrightnessWARM ColorSelect User Mode COOLLanguage ResetDot X Line Preset Mode Timing ChartVideo signal IBM PC/AT 4 Technical InformationDESCRIPTION DVI Connector PIN AssignmentSCL FOR DDC D-SUB Connector PIN AssignmentDESCRIPTION Red Green Blue Ground Self Test Red Ground Green Ground Blue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. SyncExample Plug and PlayVisual Inspection Permanently unlit or lit pixelsPoor picture or abnormal picture TroubleshootingMonitor will not turn on No picture