Xerox XA7-19i manual Federal Communications Commission FCC Statement, English

Page 4
Federal Communications Commission (FCC) Statement

FCC

Federal Communications Commission (FCC) Statement

This equipment has been tested and found to comply with the limits of a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient/Relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit which is different from what the receiver is connected to.

4.Consult the dealer or an experienced radio/TV technician for help.

CAUTION:

Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user authority to operate the equipment.

ENGLISH

Xerox© LCD Monitor User’s Manual

3

Image 4
Contents Page 2004 by Xerox Corporation. All rights reserved Table of Contents InstallationFederal Communications Commission FCC Statement IntroductionFederal Communications Commission FCC Statement ENGLISHImportant Safety Instructions WarningsDo not touch the power cord and antenna cable during lightning a. The power cord or plug is damaged b. Liquid is spilled into the productc. An object falls onto or into the product d. The product has been dropped or damagedFeatures 1 IntroductionPackage Contents Power cord specification H05 VV-F 3G 0.75mm25 POWER Front View and Controls1 MENU 2 DOWN/UPInstalling Your LCD Monitor Connecting Your LCD Monitor to a Computer 2 InstallationMethod 1 Analog D-SUB Connection Method 2 DigitalDVI Connection 2 Connect to the DVI port5o 20o Using Your LCD MonitorPOWER/ button 3 OSD MENU Using the OSD MenuEXIT Phase The OSD OptionsBrightness ContrastColor Select User ModeCOOL WARMReset LanguagePreset Mode Timing Chart Video signal IBM PC/AT4 Technical Information Dot X LineDVI Connector PIN Assignment DESCRIPTIOND-SUB Connector PIN Assignment DESCRIPTION Red Green Blue Ground Self Test Red Ground Green GroundBlue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. Sync SCL FOR DDCPlug and Play Visual InspectionPermanently unlit or lit pixels ExampleTroubleshooting Monitor will not turn onNo picture Poor picture or abnormal picture