Xerox XA7-19i manual Method 2 DigitalDVI Connection, Connect to the DVI port

Page 13

Installation

Method 2: Digital(DVI) Connection

1Turn off the computer and unplug the power cable.

2Connect the signal cable (DVI-I) to the DVI port on the back of the computer.

3Connect the AC power cable to the power socket on the back of the monitor.

4Plug the computer and monitor power cables into a nearby outlet.

5Press the POWER/ button on the front panel of the LCD monitor to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

3	4	Connect to
		wall outlet

2 Connect to the DVI port

If the screen displays “out of range”, please follow the instructions below to set up:

•Press the MENU button to display the OSD.

•Press the UP or DOWN button to highight the (INPUT SELECT) icon, then press the MENU button. The OSD displays:

DIGITAL INPUT

•Press the UP or DOWN button to select DIGITAL INPUT.

12	Xerox© LCD Monitor User’s Manual

Image 13

Contents Page 2004 by Xerox Corporation. All rights reserved Installation Table of ContentsFederal Communications Commission FCC Statement IntroductionENGLISH Federal Communications Commission FCC StatementWarnings Important Safety InstructionsDo not touch the power cord and antenna cable during lightning b. Liquid is spilled into the product a. The power cord or plug is damagedc. An object falls onto or into the product d. The product has been dropped or damaged1 Introduction FeaturesPower cord specification H05 VV-F 3G 0.75mm2 Package ContentsFront View and Controls 5 POWER1 MENU 2 DOWN/UPInstalling Your LCD Monitor Connecting Your LCD Monitor to a Computer 2 InstallationMethod 1 Analog D-SUB Connection 2 Connect to the DVI port Method 2 DigitalDVI Connection5o 20o Using Your LCD MonitorPOWER/ button 3 OSD MENU Using the OSD MenuEXIT The OSD Options PhaseBrightness ContrastSelect User Mode ColorCOOL WARMLanguage ResetVideo signal IBM PC/AT Preset Mode Timing Chart4 Technical Information Dot X LineDESCRIPTION DVI Connector PIN AssignmentDESCRIPTION Red Green Blue Ground Self Test Red Ground Green Ground D-SUB Connector PIN AssignmentBlue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. Sync SCL FOR DDCVisual Inspection Plug and PlayPermanently unlit or lit pixels ExampleMonitor will not turn on TroubleshootingNo picture Poor picture or abnormal picture