Xerox XA7-19i manual Installation, Connecting Your LCD Monitor to a Computer, English

Page 12

2 Installation

Installation

2 Installation

Refer to the owner’s manual of the computer for connections. In the process of connecting external equipment, do not connect any AC power cords to wall outlets until all other connections are completed.

Connecting Your LCD Monitor to a Computer

Method 1: Analog (D-SUB) Connection

1Turn off the computer and unplug the power cable.

2Fit the DVI-I to D-SUB adapter onto the signal cable of the LCD monitor.

3Connect the signal cable to the D-SUB port on the back of the computer.

4Connect the AC power cable to the power socket on the back of the monitor.

5Plug the computer and monitor power cables into a nearby outlet.

6Press the POWER/ button on the front panel of the LCD monitor to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

2 Attach the DVI-I to D-SUB adapter

Connect to 4 5 wall outlet

3 Connect to the D-SUB port

ENGLISH

Xerox© LCD Monitor User’s Manual

11

Image 12

Contents Page 2004 by Xerox Corporation. All rights reserved Table of Contents InstallationFederal Communications Commission FCC Statement IntroductionFederal Communications Commission FCC Statement ENGLISHImportant Safety Instructions WarningsDo not touch the power cord and antenna cable during lightning a. The power cord or plug is damaged b. Liquid is spilled into the productc. An object falls onto or into the product d. The product has been dropped or damagedFeatures 1 IntroductionPackage Contents Power cord specification H05 VV-F 3G 0.75mm25 POWER Front View and Controls1 MENU 2 DOWN/UPInstalling Your LCD Monitor 2 Installation Connecting Your LCD Monitor to a ComputerMethod 1 Analog D-SUB Connection Method 2 DigitalDVI Connection 2 Connect to the DVI portUsing Your LCD Monitor 5o 20oPOWER/ button Using the OSD Menu 3 OSD MENUEXIT Phase The OSD OptionsBrightness ContrastColor Select User ModeCOOL WARMReset LanguagePreset Mode Timing Chart Video signal IBM PC/AT4 Technical Information Dot X LineDVI Connector PIN Assignment DESCRIPTIOND-SUB Connector PIN Assignment DESCRIPTION Red Green Blue Ground Self Test Red Ground Green GroundBlue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. Sync SCL FOR DDCPlug and Play Visual InspectionPermanently unlit or lit pixels ExampleTroubleshooting Monitor will not turn onNo picture Poor picture or abnormal picture