Xerox XA7-19i manual Do not touch the power cord and antenna cable during lightning, English

Page 6
•Do not touch the power cord and antenna cable during lightning.

Important Safety Instructions

Do not touch the power cord and antenna cable during lightning.

Remove the plug from the wall outlet if the equipment will not be used for a long period of time.

Do not place, use or handle this equipment near water.

Never expose the equipment to liquid, rain, or moisture. Seek qualified service if any of the above is spilled into the equipment.

Do not attempt to service the equipment yourself.

Opening and removing the covers may expose you to dangerous voltage or other hazards and may void your warranty. Refer service to qualified personnel.

Always remove the power cord from the outlet before cleaning the equipment.

Never use liquid or aerosol cleaners on the equipment. Clean only with a soft dry cloth.

Do not expose the equipment to extreme temperature or to direct sunlight, as the equipment may heat up and suffer damage.

Do not install the equipment near any heat sources such as radiators, heat registers, stoves, or any other apparatus that might produce heat.

Do not block any ventilating openings. Leave an open space around the equipment.

Never place the equipment :on a bed, sofa, rug, or any other similar surfaces; too close to drapes/curtains/walls, in a bookcase, built-in cabinet, or any other similar places that may cause poor ventilation.

ENGLISH

(continued on next page)

Xerox© LCD Monitor User’s Manual

5

Image 6
Contents Page 2004 by Xerox Corporation. All rights reserved Federal Communications Commission FCC Statement Table of ContentsInstallation IntroductionFederal Communications Commission FCC Statement ENGLISHImportant Safety Instructions WarningsDo not touch the power cord and antenna cable during lightning c. An object falls onto or into the product a. The power cord or plug is damagedb. Liquid is spilled into the product d. The product has been dropped or damagedFeatures 1 IntroductionPackage Contents Power cord specification H05 VV-F 3G 0.75mm21 MENU 5 POWERFront View and Controls 2 DOWN/UPInstalling Your LCD Monitor 2 Installation Connecting Your LCD Monitor to a ComputerMethod 1 Analog D-SUB Connection Method 2 DigitalDVI Connection 2 Connect to the DVI portUsing Your LCD Monitor 5o 20oPOWER/ button Using the OSD Menu 3 OSD MENUEXIT Brightness PhaseThe OSD Options ContrastCOOL ColorSelect User Mode WARMReset Language4 Technical Information Preset Mode Timing ChartVideo signal IBM PC/AT Dot X LineDVI Connector PIN Assignment DESCRIPTIONBlue Ground 5 VDC Ground Ground SDA FOR DDC H. Sync V. Sync D-SUB Connector PIN AssignmentDESCRIPTION Red Green Blue Ground Self Test Red Ground Green Ground SCL FOR DDCPermanently unlit or lit pixels Plug and PlayVisual Inspection ExampleNo picture TroubleshootingMonitor will not turn on Poor picture or abnormal picture